← Wisconsin

Tap water quality report

Marshall Waterworks

EPA monitoring tested this supplier for 106 contaminants and detected 19. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

106
contaminants tested
19
detected
3,862
people served
22
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Dane

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

22
health-based violations
39
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2017-10-01 → 2017-12-31
MCL Health-based Resolved 2015-01-01 → 2015-03-31
MCL Health-based Resolved 2015-01-01 → 2015-03-31
MCL Health-based Resolved 2015-01-01 → 2015-03-31
MCL Health-based Resolved 2015-01-01 → 2015-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Fluoride
1210 µg/L 30%
of the EPA limit 4000 µg/L
worst single sample: 1280 µg/L
101/198 SYR4 2012–2019
Combined Radium (-226 And -228)
6.62 pCi/L 132%
of the EPA limit, at the 95th percentile of samples — 5 pCi/L
worst single sample: 9.18 pCi/L
49/49 SYR4 2012–2019
Copper
720.5 µg/L 55%
of the EPA limit 1300 µg/L
worst single sample: 780 µg/L
40/40 SYR4 2014–2017
Lead
2.39 µg/L 16%
of the EPA limit 15 µg/L
worst single sample: 4.1 µg/L
20/40 SYR4 2014–2017
Lead
0.00033 mg/L 2.2%
of the EPA limit 0.0150 mg/L
14/14 LCR 2023
Gross Alpha, Excl. Radon And U
13.48 pCi/L 90%
of the EPA limit 15 pCi/L
worst single sample: 13.9 pCi/L
13/13 SYR4 2012–2019
TTHM
3.392 µg/L 4.2%
of the EPA limit 80 µg/L
worst single sample: 3.46 µg/L
9/9 SYR4 2013–2019
Chloroform
2.765 µg/L
No EPA limit set
worst single sample: 2.8 µg/L
8/21 SYR4 2012–2019
Gross Beta Particle Activity
7.0885 pCi/L
No EPA limit set
worst single sample: 7.68 pCi/L
8/8 SYR4 2012–2014
Barium
106.975 µg/L 5.3%
of the EPA limit 2000 µg/L
worst single sample: 114 µg/L
6/6 SYR4 2014–2017
Nitrate
240 µg/L 2.4%
of the EPA limit 10000 µg/L
6/30 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
1.0034 µg/L 1.7%
of the EPA limit 60 µg/L
worst single sample: 1.03 µg/L
5/9 SYR4 2013–2019
Bromodichloromethane
0.8220 µg/L
No EPA limit set
worst single sample: 0.8400 µg/L
3/21 SYR4 2012–2019
Dichloroacetic Acid
0.6180 µg/L
No EPA limit set
worst single sample: 0.6200 µg/L
3/9 SYR4 2013–2019
Combined Uranium
1.48 µg/L 4.9%
of the EPA limit 30 µg/L
worst single sample: 1.5 µg/L
2/2 SYR4 2017
Arsenic
1.16 µg/L 12%
of the EPA limit 10 µg/L
1/6 SYR4 2014–2017
Dibromochloromethane
0.5100 µg/L
No EPA limit set
1/21 SYR4 2012–2019
Nitrate-Nitrite
130 µg/L 1.3%
of the EPA limit 10000 µg/L
1/12 SYR4 2012–2017
Trichloroacetic Acid
0.3600 µg/L
No EPA limit set
1/9 SYR4 2013–2019
87 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalAtrazineBhc-GammaBenzeneBeryllium, TotalBromoformChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDibromoacetic AcidDinosebDiquatEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitriteOxamylPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Frequently asked questions about Marshall Waterworks

Is Marshall Waterworks tap water safe to drink?

EPA monitoring detected 19 contaminants in Marshall Waterworks's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Marshall Waterworks's water?

EPA monitoring detected Fluoride, Combined Radium (-226 And -228), Copper, Lead, Lead, and others. The full list with the level and data source for each is above.

How many people does Marshall Waterworks serve?

Marshall Waterworks reports serving 3,862 people in Wisconsin, per its EPA record.

Has Marshall Waterworks had any water quality violations?

The EPA has 39 violations on file for Marshall Waterworks, of which 22 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.