Is Kilmers Point Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Private
Counties served: Middlesex

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2006-06-01 → 2006-06-30
MCL	Health-based	Resolved	2006-06-01 → 2006-06-30
MCL	Health-based	Resolved	2006-06-01 → 2006-06-30
MCL	Health-based	Resolved	2006-06-01 → 2006-06-30
MCL	Health-based	Resolved	2006-05-01 → 2006-05-31
MCL	Health-based	Resolved	2006-05-01 → 2006-05-31
MCL	Health-based	Resolved	2006-05-01 → 2006-05-31
MCL	Health-based	Resolved	2006-05-01 → 2006-05-31
MCL	Health-based	Archived	2000-09-01 → 2000-09-30
MCL	Health-based	Archived	2000-09-01 → 2000-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	15/15	LCR	2023
Copper	213.55 µg/L 16% of the EPA limit 1300 µg/L worst single sample: 223 µg/L	8/13	SYR4	2013–2019
Bromodichloromethane	9.18 µg/L No EPA limit set worst single sample: 9.3 µg/L	7/7	SYR4	2013–2019
Chloroform	11.4 µg/L No EPA limit set worst single sample: 12 µg/L	7/7	SYR4	2013–2019
Dibromochloromethane	6.02 µg/L No EPA limit set worst single sample: 6.2 µg/L	7/7	SYR4	2013–2019
TTHM	27.4 µg/L 34% of the EPA limit 80 µg/L worst single sample: 28 µg/L	5/5	SYR4	2013–2019
Bromoform	0.9000 µg/L No EPA limit set	4/7	SYR4	2013–2019
Dichloroacetic Acid	4.255 µg/L No EPA limit set worst single sample: 4.3 µg/L	4/4	SYR4	2014–2019
Total Haloacetic Acids (HAA5)	8.32 µg/L 14% of the EPA limit 60 µg/L worst single sample: 8.5 µg/L	4/4	SYR4	2014–2019
Arsenic	3 µg/L 30% of the EPA limit 10 µg/L	3/3	SYR4	2013–2019
Fluoride	2628 µg/L 66% of the EPA limit 4000 µg/L worst single sample: 2630 µg/L	3/3	SYR4	2013–2019
Dibromoacetic Acid	1.695 µg/L No EPA limit set worst single sample: 1.7 µg/L	2/4	SYR4	2014–2019
Lead	2.7885 µg/L 19% of the EPA limit 15 µg/L worst single sample: 2.83 µg/L	2/13	SYR4	2013–2019
Trichloroacetic Acid	2.55 µg/L No EPA limit set worst single sample: 2.6 µg/L	2/4	SYR4	2014–2019
Combined Radium (-226 And -228)	0.2000 pCi/L 4% of the EPA limit 5 pCi/L	1/1	SYR4	2017
Gross Beta Particle Activity	7.8 pCi/L No EPA limit set	1/1	SYR4	2017

33 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalBariumBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidNitrate-NitriteSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: ANGSTADT, CURT
Email: [email protected]

Frequently asked questions about Kilmers Point

Is Kilmers Point tap water safe to drink?

EPA monitoring detected 16 contaminants in Kilmers Point's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Kilmers Point's water?

EPA monitoring detected Lead, Copper, Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Kilmers Point serve?

Kilmers Point reports serving 66 people in Virginia, per its EPA record.

Has Kilmers Point had any water quality violations?

The EPA has 30 violations on file for Kilmers Point, of which 15 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.