← Utah

Tap water quality report

Summit County Service Area #3

EPA monitoring tested this supplier for 64 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

64
contaminants tested
13
detected
600
people served
3
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Summit

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
139
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2012-01-01 → 2012-03-31
MCL Health-based Resolved 2012-01-01 → 2012-03-31
MCL Health-based Resolved 2012-01-01 → 2012-03-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2024-07-01 → 2024-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Arsenic
20.15 µg/L 201%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 23.6 µg/L
331/331 SYR4 2012–2019
Nitrate
1950 µg/L 20%
of the EPA limit 10000 µg/L
worst single sample: 2000 µg/L
26/32 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
19/19 LCR 2023
Copper
386.055 µg/L 30%
of the EPA limit 1300 µg/L
worst single sample: 498 µg/L
18/20 SYR4 2013–2019
Lead
7.2 µg/L 48%
of the EPA limit 15 µg/L
worst single sample: 8.1 µg/L
7/20 SYR4 2013–2019
Selenium
1.15 µg/L 2.3%
of the EPA limit 50 µg/L
worst single sample: 1.2 µg/L
6/6 SYR4 2013–2018
Gross Beta Particle Activity
7.6 pCi/L
No EPA limit set
worst single sample: 7.7 pCi/L
5/5 SYR4 2013–2019
Barium
134.41 µg/L 6.7%
of the EPA limit 2000 µg/L
worst single sample: 145.6 µg/L
4/4 SYR4 2013–2018
Fluoride
714.24 µg/L 18%
of the EPA limit 4000 µg/L
worst single sample: 734.4 µg/L
4/4 SYR4 2013–2018
Gross Alpha, Excl. Radon And U
2.89 pCi/L 19%
of the EPA limit 15 pCi/L
worst single sample: 3.1 pCi/L
3/5 SYR4 2013–2019
Chromium
8.24 µg/L 8.2%
of the EPA limit 100 µg/L
worst single sample: 8.4 µg/L
2/6 SYR4 2013–2018
Nitrate-Nitrite
1074.03 µg/L 11%
of the EPA limit 10000 µg/L
worst single sample: 1111.9 µg/L
2/2 SYR4 2018
Cyanide
4 µg/L 2%
of the EPA limit 200 µg/L
1/4 SYR4 2013–2018
51 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ANAGNOS, JODY
Phone
435-500-6276
Email
[email protected]

Frequently asked questions about Summit County Service Area #3

Is Summit County Service Area #3 tap water safe to drink?

EPA monitoring detected 13 contaminants in Summit County Service Area #3's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Summit County Service Area #3's water?

EPA monitoring detected Arsenic, Nitrate, Lead, Copper, Lead, and others. The full list with the level and data source for each is above.

How many people does Summit County Service Area #3 serve?

Summit County Service Area #3 reports serving 600 people in Utah, per its EPA record.

Has Summit County Service Area #3 had any water quality violations?

The EPA has 139 violations on file for Summit County Service Area #3, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.