← Texas

Tap water quality report

City of Stamford

EPA monitoring tested this supplier for 79 contaminants and detected 25. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

79
contaminants tested
25
detected
3,101
people served
50
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
Jones

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

50
health-based violations
123
violations on file
1
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2015-09-01
TT Health-based Resolved 2015-09-01
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30
MCL Health-based Resolved 2015-07-01 → 2015-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Chlorite
572.8 µg/L 57%
of the EPA limit 1000 µg/L
worst single sample: 895 µg/L
147/222 SYR4 2013–2019
Copper
526.4 µg/L 40%
of the EPA limit 1300 µg/L
worst single sample: 2010 µg/L
135/135 SYR4 2013–2017
Lead
25.135 µg/L 168%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 71.8 µg/L
104/135 SYR4 2013–2017
Bromodichloromethane
18.545 µg/L
No EPA limit set
worst single sample: 23.5 µg/L
60/60 SYR4 2012–2019
Dibromochloromethane
35.65 µg/L
No EPA limit set
worst single sample: 43.9 µg/L
60/60 SYR4 2012–2019
Bromoform
95.31 µg/L
No EPA limit set
worst single sample: 104.8 µg/L
58/60 SYR4 2012–2019
Chloroform
12.46 µg/L
No EPA limit set
worst single sample: 23 µg/L
57/60 SYR4 2012–2019
TTHM
139.805 µg/L 175%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 162.1 µg/L
52/53 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
58.35 µg/L 97%
of the EPA limit 60 µg/L
worst single sample: 64 µg/L
51/52 SYR4 2012–2019
Dichloroacetic Acid
18.36 µg/L
No EPA limit set
worst single sample: 26.3 µg/L
49/52 SYR4 2012–2019
Dibromoacetic Acid
43.655 µg/L
No EPA limit set
worst single sample: 47 µg/L
48/52 SYR4 2012–2019
Monobromoacetic Acid
4.955 µg/L
No EPA limit set
worst single sample: 5.2 µg/L
44/52 SYR4 2012–2019
Trichloroacetic Acid
7.495 µg/L
No EPA limit set
worst single sample: 11.4 µg/L
42/52 SYR4 2012–2019
Monochloroacetic Acid
20.2 µg/L
No EPA limit set
worst single sample: 34.5 µg/L
21/52 SYR4 2012–2019
Nitrate
314 µg/L 3.1%
of the EPA limit 10000 µg/L
18/18 SYR4 2012–2019
Lead
0.0087 mg/L 58%
of the EPA limit 0.0150 mg/L
16/16 LCR 2025
Fluoride
448.7 µg/L 11%
of the EPA limit 4000 µg/L
worst single sample: 462 µg/L
8/8 SYR4 2012–2019
Arsenic
6.223 µg/L 62%
of the EPA limit 10 µg/L
worst single sample: 6.7 µg/L
7/7 SYR4 2013–2019
Barium
277 µg/L 14%
of the EPA limit 2000 µg/L
worst single sample: 280 µg/L
7/7 SYR4 2013–2019
Antimony, Total
0.8842 µg/L 15%
of the EPA limit 6 µg/L
worst single sample: 0.8850 µg/L
4/7 SYR4 2013–2019
Cyanide
101.2 µg/L 51%
of the EPA limit 200 µg/L
worst single sample: 115 µg/L
4/6 SYR4 2014–2019
Selenium
9.554 µg/L 19%
of the EPA limit 50 µg/L
worst single sample: 11 µg/L
4/7 SYR4 2013–2019
Chromium
6.789 µg/L 6.8%
of the EPA limit 100 µg/L
worst single sample: 7.06 µg/L
3/7 SYR4 2013–2019
Combined Radium (-226 And -228)
1.5 pCi/L 30%
of the EPA limit 5 pCi/L
1/1 SYR4 2015
Gross Beta Particle Activity
13 pCi/L
No EPA limit set
1/1 SYR4 2015
54 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ANDERS, JOHNNY
Phone
325-773-3024

Frequently asked questions about City of Stamford

Is City of Stamford tap water safe to drink?

EPA monitoring detected 25 contaminants in City of Stamford's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in City of Stamford's water?

EPA monitoring detected Chlorite, Copper, Lead, Bromodichloromethane, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does City of Stamford serve?

City of Stamford reports serving 3,101 people in Texas, per its EPA record.

Has City of Stamford had any water quality violations?

The EPA has 123 violations on file for City of Stamford, of which 50 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.