Compliance record
Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.
124
health-based violations
226
violations on file
1
still open
| Violation | Type | Status | Period |
|---|---|---|---|
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-04-01 → 2025-06-30 |
| MCL | Health-based | Resolved | 2025-01-01 → 2025-03-31 |
| MCL | Health-based | Resolved | 2025-01-01 → 2025-03-31 |
PFAS detected
PFAS are industrial “forever chemicals”. These are the EPA's latest
nationwide test results (2023–2025).
Other contaminants detected
Each bar shows the measured level as a share of the EPA limit: green is
well under, amber is close to it, red is over. For lead and copper the
limit applies to exactly the 90th-percentile figure shown, so red there
means a real exceedance. For everything else the limit applies to a
running annual average while the figure is the 95th percentile of this
system's samples — over 100% is worth reading, but is not by itself a
violation. Where a single sample came in higher than that percentile, it
is noted under the bar. Formal violations are listed separately.
| Contaminant | Level vs EPA limit | Detection rate | Source | Period |
|---|---|---|---|---|
| Bromodichloromethane | 23.465 µg/L No EPA limit set
worst single sample: 53.2 µg/L | 70/70 | SYR4 | 2012–2019 |
| Dibromochloromethane | 31.055 µg/L No EPA limit set
worst single sample: 44.3 µg/L | 70/70 | SYR4 | 2012–2019 |
| TTHM | 108.9 µg/L 136% of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 222 µg/L | 63/63 | SYR4 | 2012–2019 |
| Total Haloacetic Acids (HAA5) | 60.64 µg/L 101% of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 107 µg/L | 63/63 | SYR4 | 2012–2019 |
| Bromoform | 57.375 µg/L No EPA limit set
worst single sample: 126 µg/L | 62/70 | SYR4 | 2012–2019 |
| Dibromoacetic Acid | 24.005 µg/L No EPA limit set
worst single sample: 29.5 µg/L | 60/63 | SYR4 | 2012–2019 |
| Copper | 198.4 µg/L 15% of the EPA limit 1300 µg/L
worst single sample: 282 µg/L | 54/66 | SYR4 | 2012–2019 |
| Dichloroacetic Acid | 42.05 µg/L No EPA limit set
worst single sample: 70.2 µg/L | 51/63 | SYR4 | 2012–2019 |
| Chloroform | 42.975 µg/L No EPA limit set
worst single sample: 156 µg/L | 46/70 | SYR4 | 2012–2019 |
| Monobromoacetic Acid | 4.33 µg/L No EPA limit set
worst single sample: 5.1 µg/L | 40/63 | SYR4 | 2012–2019 |
| Nitrate | 525 µg/L 5.3% of the EPA limit 10000 µg/L
worst single sample: 870 µg/L | 36/36 | SYR4 | 2012–2019 |
| Trichloroacetic Acid | 28.1 µg/L No EPA limit set
worst single sample: 35.4 µg/L | 34/63 | SYR4 | 2012–2019 |
| Monochloroacetic Acid | 14.59 µg/L No EPA limit set
worst single sample: 23.9 µg/L | 20/63 | SYR4 | 2012–2019 |
| Cyanide | 176.85 µg/L 88% of the EPA limit 200 µg/L
worst single sample: 210 µg/L | 18/18 | SYR4 | 2014–2019 |
| Lead | 0.0068 mg/L 45% of the EPA limit 0.0150 mg/L | 11/11 | LCR | 2025 |
| Lead | 8.515 µg/L 57% of the EPA limit 15 µg/L
worst single sample: 11.2 µg/L | 11/66 | SYR4 | 2012–2019 |
| Nitrite | 740 µg/L 74% of the EPA limit 1000 µg/L
worst single sample: 770 µg/L | 11/21 | SYR4 | 2012–2019 |
| Barium | 214.45 µg/L 11% of the EPA limit 2000 µg/L
worst single sample: 233 µg/L | 8/8 | SYR4 | 2012–2019 |
| Fluoride | 277 µg/L 6.9% of the EPA limit 4000 µg/L
worst single sample: 340 µg/L | 8/8 | SYR4 | 2012–2019 |
| Nitrate-Nitrite | 1357.5 µg/L 14% of the EPA limit 10000 µg/L
worst single sample: 1640 µg/L | 6/6 | SYR4 | 2012–2019 |
| Arsenic | 3.54 µg/L 35% of the EPA limit 10 µg/L
worst single sample: 3.7 µg/L | 5/8 | SYR4 | 2012–2019 |
| Chromium | 0.6152 µg/L 0.6% of the EPA limit 100 µg/L
worst single sample: 0.6180 µg/L | 2/8 | SYR4 | 2012–2019 |
| Selenium | 7.0085 µg/L 14% of the EPA limit 50 µg/L
worst single sample: 7.2 µg/L | 2/8 | SYR4 | 2012–2019 |
| Lithium | 15.1 µg/L No EPA limit set | 2/6 | UCMR-5 | 2025 |
| Dalapon | 1.2 µg/L 0.6% of the EPA limit 200 µg/L | 1/32 | SYR4 | 2012–2019 |
| Gross Beta Particle Activity | 9.7 pCi/L No EPA limit set | 1/1 | SYR4 | 2017 |
| Xylenes, Total | 2.98 µg/L 0% of the EPA limit 10000 µg/L | 1/7 | SYR4 | 2012–2019 |
72 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNetfosaaNfdhaNmefosaaOxamylPfdaPfdoaPfeesaPfhpsPfmbaPfmpaPFNAPfpesPftaPftrdaPfunaPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene
Utility contact
Frequently asked questions about City of Clyde
Is City of Clyde tap water safe to drink?
EPA monitoring detected 36 contaminants in City of Clyde's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.
What contaminants were detected in City of Clyde's water?
EPA monitoring detected Bromodichloromethane, Dibromochloromethane, TTHM, Total Haloacetic Acids (HAA5), Bromoform, and others. The full list with the level and data source for each is above.
How many people does City of Clyde serve?
City of Clyde reports serving 3,820 people in Texas, per its EPA record.
Has City of Clyde had any water quality violations?
The EPA has 226 violations on file for City of Clyde, of which 124 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.
Where does this data come from?
Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.