Tap WaterIndex

← Oklahoma

Tap water quality report

Highpoint Mhp

EPA monitoring tested this supplier for 50 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
20
detected
600
people served
53
health-based violations
Oklahoma rankingsLead in OklahomaPFAS in Oklahoma
Water source
Ground water
Ownership
Private
Counties served
Garfield

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

53
health-based violations
394
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
MCL Health-based Resolved 2009-01-01 → 2009-12-31
MCL Health-based Resolved 2009-01-01 → 2009-12-31
MCL Health-based Resolved 2009-01-01 → 2009-12-31
MCL Health-based Resolved 2009-01-01 → 2009-12-31
MCL Health-based Resolved 2009-01-01 → 2009-12-31
MCL Health-based Resolved 2006-07-01 → 2006-09-30
MCL Health-based Resolved 2006-07-01 → 2006-09-30
MCL Health-based Resolved 2006-07-01 → 2006-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate-Nitrite
6940 µg/L 69%
of the EPA limit 10000 µg/L
worst single sample: 9560 µg/L
100/100 SYR4 2012–2019
Copper
460.75 µg/L 35%
of the EPA limit 1300 µg/L
worst single sample: 2510 µg/L
66/70 SYR4 2012–2017
Chloroform
2.095 µg/L
No EPA limit set
worst single sample: 3.09 µg/L
40/67 SYR4 2012–2019
Tetrachloroethylene
7.0135 µg/L 140%
of the EPA limit, at the 95th percentile of samples — 5 µg/L
worst single sample: 11.4 µg/L
30/59 SYR4 2012–2019
Lead
21.465 µg/L 143%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 322 µg/L
24/70 SYR4 2012–2017
Bromodichloromethane
1.553 µg/L
No EPA limit set
worst single sample: 1.91 µg/L
18/67 SYR4 2012–2019
Lead
0.0107 mg/L 71%
of the EPA limit 0.0150 mg/L
 15/15 LCR 2023
Barium
496.8 µg/L 25%
of the EPA limit 2000 µg/L
worst single sample: 515 µg/L
14/14 SYR4 2012–2017
Fluoride
187 µg/L 4.7%
of the EPA limit 4000 µg/L
worst single sample: 200 µg/L
14/14 SYR4 2012–2017
Gross Beta Particle Activity
12.031 pCi/L
No EPA limit set
worst single sample: 17.4 pCi/L
14/14 SYR4 2012–2019
Combined Radium (-226 And -228)
1.448 pCi/L 29%
of the EPA limit 5 pCi/L
worst single sample: 1.46 pCi/L
13/14 SYR4 2012–2019
Gross Alpha, Excl. Radon And U
6.8135 pCi/L 45%
of the EPA limit 15 pCi/L
worst single sample: 7.71 pCi/L
12/14 SYR4 2012–2019
Dibromochloromethane
1.608 µg/L
No EPA limit set
worst single sample: 1.74 µg/L
9/67 SYR4 2012–2019
Bromoform
1.4565 µg/L
No EPA limit set
worst single sample: 1.46 µg/L
8/67 SYR4 2012–2019
TTHM
3.269 µg/L 4.1%
of the EPA limit 80 µg/L
worst single sample: 3.47 µg/L
3/8 SYR4 2012–2019
Dibromoacetic Acid
1.0675 µg/L
No EPA limit set
worst single sample: 1.07 µg/L
2/8 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
2.312 µg/L 3.9%
of the EPA limit 60 µg/L
worst single sample: 2.38 µg/L
2/8 SYR4 2012–2019
1,2-Dichloroethane
0.6100 µg/L 12%
of the EPA limit 5 µg/L
 1/59 SYR4 2012–2019
Thallium, Total
1 µg/L 50%
of the EPA limit 2 µg/L
 1/14 SYR4 2012–2017
Trichloroacetic Acid
1.31 µg/L
No EPA limit set
 1/8 SYR4 2012–2019
30 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalChlorobenzeneCadmiumCarbon TetrachlorideChromiumCombined UraniumDichloromethaneDichloroacetic AcidEthylbenzeneMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
HIGHPOINT MHP
Phone
580-234-1726
Email
[email protected]

Frequently asked questions about Highpoint Mhp

Is Highpoint Mhp tap water safe to drink?

EPA monitoring detected 20 contaminants in Highpoint Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Highpoint Mhp's water?

EPA monitoring detected Nitrate-Nitrite, Copper, Chloroform, Tetrachloroethylene, Lead, and others. The full list with the level and data source for each is above.

How many people does Highpoint Mhp serve?

Highpoint Mhp reports serving 600 people in Oklahoma, per its EPA record.

Has Highpoint Mhp had any water quality violations?

The EPA has 394 violations on file for Highpoint Mhp, of which 53 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.