Tap WaterIndex

← North Carolina

Tap water quality report

Saddle Run S/D

EPA monitoring tested this supplier for 78 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
15
detected
589
people served
3
health-based violations
North Carolina rankingsLead in North CarolinaPFAS in North Carolina
Water source
Ground water
Ownership
Private
Counties served
Wake

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
11
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2004-05-01 → 2004-05-31
MCL Health-based Resolved 2004-05-01 → 2004-05-31
MCL Health-based Resolved 2004-05-01 → 2004-05-31
RPT Monitoring Resolved 2023-07-01
RPT Monitoring Resolved 2023-07-01
RPT Monitoring Resolved 2023-07-01
RPT Monitoring Resolved 2023-07-01
RPT Monitoring Resolved 2023-07-01
Other Monitoring Resolved 2002-07-01
Other Monitoring Resolved 2002-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
478.05 µg/L 37%
of the EPA limit 1300 µg/L
worst single sample: 609 µg/L
10/25 SYR4 2014–2017
TTHM
18.8 µg/L 24%
of the EPA limit 80 µg/L
worst single sample: 20 µg/L
9/10 SYR4 2013–2019
Bromodichloromethane
6.6 µg/L
No EPA limit set
worst single sample: 6.8 µg/L
6/7 SYR4 2014–2019
Dibromochloromethane
5.05 µg/L
No EPA limit set
worst single sample: 5.2 µg/L
6/7 SYR4 2014–2019
Fluoride
310 µg/L 7.8%
of the EPA limit 4000 µg/L
worst single sample: 320 µg/L
6/9 SYR4 2012–2019
Chloroform
6.38 µg/L
No EPA limit set
worst single sample: 6.4 µg/L
5/7 SYR4 2014–2019
Bromoform
3.19 µg/L
No EPA limit set
worst single sample: 3.4 µg/L
4/7 SYR4 2014–2019
Dibromoacetic Acid
1.76 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
3/7 SYR4 2014–2019
Trichloroacetic Acid
2.49 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
3/7 SYR4 2014–2019
Dichloroacetic Acid
3.455 µg/L
No EPA limit set
worst single sample: 3.5 µg/L
2/7 SYR4 2014–2019
Gross Beta Particle Activity
4.475 pCi/L
No EPA limit set
worst single sample: 4.5 pCi/L
2/3 SYR4 2016
Lead
53.835 µg/L 359%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 55.8 µg/L
2/25 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
7.37 µg/L 12%
of the EPA limit 60 µg/L
worst single sample: 7.5 µg/L
2/10 SYR4 2013–2019
Combined Radium (-226 And -228)
1.3 pCi/L 26%
of the EPA limit 5 pCi/L
 1/3 SYR4 2016
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 1/1 LCR 2025
63 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
MILLIRON, BRENT
Phone
919-653-6999
Email
[email protected]

Frequently asked questions about Saddle Run S/D

Is Saddle Run S/D tap water safe to drink?

EPA monitoring detected 15 contaminants in Saddle Run S/D's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Saddle Run S/D's water?

EPA monitoring detected Copper, TTHM, Bromodichloromethane, Dibromochloromethane, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Saddle Run S/D serve?

Saddle Run S/D reports serving 589 people in North Carolina, per its EPA record.

Has Saddle Run S/D had any water quality violations?

The EPA has 11 violations on file for Saddle Run S/D, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.