← Maryland

Tap water quality report

Persimmon Hills

EPA monitoring tested this supplier for 72 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

72
contaminants tested
12
detected
514
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
St. Mary's

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
7
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Archived 2022-09-01 → 2023-08-31
MR Monitoring Archived 2022-09-01 → 2023-08-31
MR Monitoring Archived 2022-09-01 → 2023-08-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31
MR Monitoring Resolved 2022-01-01 → 2022-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
11/11 LCR 2024
TTHM
4.485 µg/L 5.6%
of the EPA limit 80 µg/L
worst single sample: 5.1 µg/L
7/8 SYR4 2013–2019
Chloroform
5.3 µg/L
No EPA limit set
worst single sample: 6.33 µg/L
6/10 SYR4 2012–2017
Barium
36.4 µg/L 1.8%
of the EPA limit 2000 µg/L
worst single sample: 39 µg/L
5/6 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
7.68 µg/L 13%
of the EPA limit 60 µg/L
worst single sample: 9.2 µg/L
5/8 SYR4 2013–2019
Bromodichloromethane
0.8570 µg/L
No EPA limit set
worst single sample: 0.8600 µg/L
4/10 SYR4 2012–2017
Arsenic
5.68 µg/L 57%
of the EPA limit 10 µg/L
worst single sample: 5.8 µg/L
3/7 SYR4 2014–2019
Gross Beta Particle Activity
13.28 pCi/L
No EPA limit set
worst single sample: 14.3 pCi/L
3/5 SYR4 2012
Fluoride
199 µg/L 5%
of the EPA limit 4000 µg/L
worst single sample: 200 µg/L
2/3 SYR4 2014–2019
Dichloroacetic Acid
1 µg/L
No EPA limit set
1/3 SYR4 2013–2014
Trichloroacetic Acid
0.5400 µg/L
No EPA limit set
1/3 SYR4 2013–2014
Xylenes, Total
6 µg/L 0.1%
of the EPA limit 10000 µg/L
1/10 SYR4 2012–2019
60 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDibromochloromethaneDinosebEthylene DibromideEndrinEthylbenzeneGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitrateNitrate-NitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
CANTRELL, DWAYNE
Phone
240-925-3139
Email
[email protected]

Frequently asked questions about Persimmon Hills

Is Persimmon Hills tap water safe to drink?

EPA monitoring detected 12 contaminants in Persimmon Hills's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Persimmon Hills's water?

EPA monitoring detected Lead, TTHM, Chloroform, Barium, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Persimmon Hills serve?

Persimmon Hills reports serving 514 people in Maryland, per its EPA record.

Has Persimmon Hills had any water quality violations?

The EPA has 7 violations on file for Persimmon Hills, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.