← Louisiana

Tap water quality report

Empire Point Community Water

EPA monitoring tested this supplier for 80 contaminants and detected 19. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
19
detected
69
people served
4
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Vernon Parish

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
18
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2010-04-01 → 2010-04-30
MCL Health-based Resolved 2010-04-01 → 2010-04-30
MCL Health-based Resolved 2010-04-01 → 2010-04-30
MCL Health-based Resolved 2010-04-01 → 2010-04-30
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31
MR Monitoring Resolved 2014-01-01 → 2014-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
360 µg/L 28%
of the EPA limit 1300 µg/L
worst single sample: 400 µg/L
9/17 SYR4 2012–2018
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
9/9 LCR 2024
Combined Radium (-226 And -228)
2.608 pCi/L 52%
of the EPA limit 5 pCi/L
worst single sample: 2.65 pCi/L
8/8 SYR4 2017–2019
Lead
4 µg/L 27%
of the EPA limit 15 µg/L
worst single sample: 5 µg/L
6/17 SYR4 2012–2018
Fluoride
300 µg/L 7.5%
of the EPA limit 4000 µg/L
4/4 SYR4 2014–2017
Arsenic
0.9805 µg/L 9.8%
of the EPA limit 10 µg/L
worst single sample: 1 µg/L
2/4 SYR4 2014–2017
Barium
83.35 µg/L 4.2%
of the EPA limit 2000 µg/L
worst single sample: 84 µg/L
2/4 SYR4 2014–2017
Bromodichloromethane
0.4400 µg/L
No EPA limit set
2/14 SYR4 2013–2019
Chloroform
0.4285 µg/L
No EPA limit set
worst single sample: 0.4300 µg/L
2/14 SYR4 2013–2019
Dalapon
3.84 µg/L 1.9%
of the EPA limit 200 µg/L
2/4 SYR4 2014–2017
Dibromochloromethane
0.5475 µg/L
No EPA limit set
worst single sample: 0.5500 µg/L
2/14 SYR4 2013–2019
Dichloroacetic Acid
0.8440 µg/L
No EPA limit set
worst single sample: 0.8500 µg/L
2/14 SYR4 2013–2019
Gross Beta Particle Activity
3.734 pCi/L
No EPA limit set
worst single sample: 3.76 pCi/L
2/4 SYR4 2014–2017
Nitrate-Nitrite
28 µg/L 0.3%
of the EPA limit 10000 µg/L
2/18 SYR4 2012–2019
Pentachlorophenol
0.0500 µg/L 5%
of the EPA limit 1 µg/L
2/4 SYR4 2014–2017
TTHM
1.414 µg/L 1.8%
of the EPA limit 80 µg/L
worst single sample: 1.42 µg/L
2/14 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
1.1835 µg/L 2%
of the EPA limit 60 µg/L
worst single sample: 1.19 µg/L
2/14 SYR4 2013–2019
Trichloroacetic Acid
0.3395 µg/L
No EPA limit set
worst single sample: 0.3400 µg/L
2/14 SYR4 2013–2019
Di(2-ethylhexyl) Phthalate
0.9400 µg/L 16%
of the EPA limit 6 µg/L
1/4 SYR4 2014–2017
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDi(2-ethylhexyl) AdipateDibromoacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WILKERSON, JERRY
Email
[email protected]

Frequently asked questions about Empire Point Community Water

Is Empire Point Community Water tap water safe to drink?

EPA monitoring detected 19 contaminants in Empire Point Community Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Empire Point Community Water's water?

EPA monitoring detected Copper, Lead, Combined Radium (-226 And -228), Lead, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Empire Point Community Water serve?

Empire Point Community Water reports serving 69 people in Louisiana, per its EPA record.

Has Empire Point Community Water had any water quality violations?

The EPA has 18 violations on file for Empire Point Community Water, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.