← Wyoming

Tap water quality report

Teton Village Water & Sewer District

EPA monitoring tested this supplier for 79 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

79
contaminants tested
13
detected
906
people served
1
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Teton

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
10
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2005-06-01 → 2005-06-30
MON Monitoring Resolved 2024-04-01 → 2024-04-30
MR Monitoring Resolved 2014-10-01 → 2014-10-31
MR Monitoring Resolved 2012-01-01
MR Monitoring Resolved 1997-01-01 → 1997-12-31
MR Monitoring Archived 1994-08-01 → 1994-08-31
MR Monitoring Archived 1994-03-01 → 1994-03-31
MR Monitoring Archived 1992-09-01 → 1992-09-30
MR Monitoring Archived 1992-09-01 → 1992-09-30
MR Monitoring Archived 1992-03-01 → 1992-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
154 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 760 µg/L
37/40 SYR4 2014–2019
Nitrate-Nitrite
200 µg/L 2%
of the EPA limit 10000 µg/L
34/48 SYR4 2012–2019
TTHM
7.05 µg/L 8.8%
of the EPA limit 80 µg/L
worst single sample: 9.8 µg/L
11/15 SYR4 2012–2019
Bromodichloromethane
2.14 µg/L
No EPA limit set
worst single sample: 2.7 µg/L
8/13 SYR4 2014–2019
Chloroform
4.5145 µg/L
No EPA limit set
worst single sample: 6.1 µg/L
8/13 SYR4 2014–2019
Lead
5 µg/L 33%
of the EPA limit 15 µg/L
8/40 SYR4 2014–2019
Lead
0.0020 mg/L 13%
of the EPA limit 0.0150 mg/L
7/7 LCR 2025
Fluoride
200 µg/L 5%
of the EPA limit 4000 µg/L
5/6 SYR4 2014–2019
Combined Uranium
1.16 µg/L 3.9%
of the EPA limit 30 µg/L
worst single sample: 1.2 µg/L
3/4 SYR4 2013–2019
Gross Alpha, Excl. Radon And U
3.97 pCi/L 26%
of the EPA limit 15 pCi/L
worst single sample: 4 pCi/L
3/6 SYR4 2013–2019
Combined Radium (-226 And -228)
3.015 pCi/L 60%
of the EPA limit 5 pCi/L
worst single sample: 3.1 pCi/L
2/3 SYR4 2019
Dibromochloromethane
0.9865 µg/L
No EPA limit set
worst single sample: 1 µg/L
2/13 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
1.1 µg/L 1.8%
of the EPA limit 60 µg/L
1/9 SYR4 2012–2019
66 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
JEFFRIES, ARTHUR
Phone
307-733-9231
Email
[email protected]

Frequently asked questions about Teton Village Water & Sewer District

Is Teton Village Water & Sewer District tap water safe to drink?

EPA monitoring detected 13 contaminants in Teton Village Water & Sewer District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Teton Village Water & Sewer District's water?

EPA monitoring detected Copper, Nitrate-Nitrite, TTHM, Bromodichloromethane, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Teton Village Water & Sewer District serve?

Teton Village Water & Sewer District reports serving 906 people in Wyoming, per its EPA record.

Has Teton Village Water & Sewer District had any water quality violations?

The EPA has 10 violations on file for Teton Village Water & Sewer District, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.