← West Virginia

Tap water quality report

Alpine Lake Public Utilities

EPA monitoring tested this supplier for 78 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
20
detected
1,325
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Preston

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
38
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2023-10-01
Other Monitoring Resolved 2023-10-01
Other Monitoring Resolved 2022-07-01
Other Monitoring Resolved 2022-07-01
MR Monitoring Resolved 2003-06-01 → 2003-06-30
MR Monitoring Resolved 2003-06-01 → 2003-06-30
MR Monitoring Resolved 2003-06-01 → 2003-06-30
MR Monitoring Resolved 2003-06-01 → 2003-06-30
MR Monitoring Resolved 2002-10-01 → 2002-10-31
MR Monitoring Resolved 2002-10-01 → 2002-10-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
1119 µg/L 86%
of the EPA limit 1300 µg/L
worst single sample: 1500 µg/L
40/40 SYR4 2013–2019
Lead
7.75 µg/L 52%
of the EPA limit 15 µg/L
worst single sample: 16 µg/L
31/40 SYR4 2013–2019
Lead
0.00054 mg/L 3.6%
of the EPA limit 0.0150 mg/L
12/12 LCR 2023
Nitrate
250 µg/L 2.5%
of the EPA limit 10000 µg/L
10/10 SYR4 2012–2019
Dichloroacetic Acid
6.298 µg/L
No EPA limit set
worst single sample: 7.6 µg/L
7/7 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
20.94 µg/L 35%
of the EPA limit 60 µg/L
worst single sample: 24 µg/L
7/7 SYR4 2013–2019
Bromodichloromethane
4.1825 µg/L
No EPA limit set
worst single sample: 4.21 µg/L
6/7 SYR4 2013–2019
Chloroform
24.525 µg/L
No EPA limit set
worst single sample: 29.9 µg/L
6/7 SYR4 2013–2019
Dibromochloromethane
2.3225 µg/L
No EPA limit set
worst single sample: 2.46 µg/L
6/7 SYR4 2013–2019
TTHM
29.3 µg/L 37%
of the EPA limit 80 µg/L
worst single sample: 34.7 µg/L
6/7 SYR4 2013–2019
Trichloroacetic Acid
4.2175 µg/L
No EPA limit set
worst single sample: 5.1 µg/L
6/7 SYR4 2013–2019
Monochloroacetic Acid
16.277 µg/L
No EPA limit set
worst single sample: 17.3 µg/L
3/7 SYR4 2013–2019
Nitrate-Nitrite
297.5 µg/L 3%
of the EPA limit 10000 µg/L
worst single sample: 300 µg/L
2/2 SYR4 2018–2019
Barium
180 µg/L 9%
of the EPA limit 2000 µg/L
1/1 SYR4 2019
Bromoform
0.2700 µg/L
No EPA limit set
1/7 SYR4 2013–2019
Dibromoacetic Acid
0.4310 µg/L
No EPA limit set
1/7 SYR4 2013–2019
Fluoride
90 µg/L 2.3%
of the EPA limit 4000 µg/L
1/1 SYR4 2019
Gross Alpha, Excl. Radon And U
2.34 pCi/L 16%
of the EPA limit 15 pCi/L
1/2 SYR4 2013–2019
Monobromoacetic Acid
2.08 µg/L
No EPA limit set
1/7 SYR4 2013–2019
Nitrite
50 µg/L 5%
of the EPA limit 1000 µg/L
1/2 SYR4 2018–2019
58 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneGross Beta Particle ActivityHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
MAYNE, KIM
Phone
304-789-6996
Email
[email protected]

Frequently asked questions about Alpine Lake Public Utilities

Is Alpine Lake Public Utilities tap water safe to drink?

EPA monitoring detected 20 contaminants in Alpine Lake Public Utilities's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Alpine Lake Public Utilities's water?

EPA monitoring detected Copper, Lead, Lead, Nitrate, Dichloroacetic Acid, and others. The full list with the level and data source for each is above.

How many people does Alpine Lake Public Utilities serve?

Alpine Lake Public Utilities reports serving 1,325 people in West Virginia, per its EPA record.

Has Alpine Lake Public Utilities had any water quality violations?

The EPA has 38 violations on file for Alpine Lake Public Utilities, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.