Tap WaterIndex

← Illinois

Tap water quality report

Brookside Meadows Mhp

EPA monitoring tested this supplier for 64 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

64
contaminants tested
9
detected
250
people served
6
health-based violations
Illinois rankingsLead in IllinoisPFAS in Illinois
Water source
Ground water
Ownership
Private
Counties served
Washington

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

6
health-based violations
10
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-10-01 → 2011-10-31
Other Monitoring Resolved 2023-07-01
Other Monitoring Resolved 2023-07-01
Other Monitoring Resolved 2023-07-01
Other Monitoring Resolved 2023-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
293.3 µg/L 23%
of the EPA limit 1300 µg/L
worst single sample: 364 µg/L
15/15 SYR4 2012–2018
Lead
5.862 µg/L 39%
of the EPA limit 15 µg/L
worst single sample: 8.04 µg/L
13/15 SYR4 2012–2018
Lead
0.0033 mg/L 22%
of the EPA limit 0.0150 mg/L
 9/9 LCR 2024
Arsenic
2.3959 µg/L 24%
of the EPA limit 10 µg/L
worst single sample: 2.411 µg/L
3/3 SYR4 2012–2018
Barium
248.85 µg/L 12%
of the EPA limit 2000 µg/L
worst single sample: 249 µg/L
3/3 SYR4 2012–2018
Chromium
1.74154 µg/L 1.7%
of the EPA limit 100 µg/L
worst single sample: 1.79 µg/L
2/3 SYR4 2012–2018
Combined Radium (-226 And -228)
1.8965 pCi/L 38%
of the EPA limit 5 pCi/L
worst single sample: 1.94 pCi/L
2/2 SYR4 2012–2015
Fluoride
216.65 µg/L 5.4%
of the EPA limit 4000 µg/L
worst single sample: 217 µg/L
2/3 SYR4 2012–2018
Gross Alpha, Excl. Radon And U
1.795 pCi/L 12%
of the EPA limit 15 pCi/L
worst single sample: 1.8 pCi/L
2/2 SYR4 2012–2015
55 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitrateNitrate-NitriteNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Frequently asked questions about Brookside Meadows Mhp

Is Brookside Meadows Mhp tap water safe to drink?

EPA monitoring detected 9 contaminants in Brookside Meadows Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Brookside Meadows Mhp's water?

EPA monitoring detected Copper, Lead, Lead, Arsenic, Barium, and others. The full list with the level and data source for each is above.

How many people does Brookside Meadows Mhp serve?

Brookside Meadows Mhp reports serving 250 people in Illinois, per its EPA record.

Has Brookside Meadows Mhp had any water quality violations?

The EPA has 10 violations on file for Brookside Meadows Mhp, of which 6 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.