Tap WaterIndex

← Washington

Tap water quality report

Pullman Water Department City of

EPA monitoring tested this supplier for 103 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

103
contaminants tested
14
detected
31,315
people served
0
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Local government
Counties served
Whitman

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
15
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2023-01-01 → 2023-12-31
MR Monitoring Resolved 2023-01-01 → 2023-12-31
MR Monitoring Resolved 2023-01-01 → 2023-12-31
MON Monitoring Resolved 2021-04-01 → 2021-04-30
MON Monitoring Resolved 2020-06-01 → 2020-06-30
MR Monitoring Resolved 2020-01-01
Other Monitoring Resolved 2017-07-01
MR Monitoring Resolved 2016-01-01 → 2016-12-31
Other Monitoring Resolved 2015-07-01
Other Monitoring Resolved 2014-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
6.0655 µg/L 7.6%
of the EPA limit 80 µg/L
worst single sample: 7.65 µg/L
92/92 SYR4 2012–2019
Chloroform
1.3395 µg/L
No EPA limit set
worst single sample: 1.92 µg/L
88/103 SYR4 2012–2019
Dibromochloromethane
2.258 µg/L
No EPA limit set
worst single sample: 2.83 µg/L
83/105 SYR4 2012–2019
Bromodichloromethane
1.513 µg/L
No EPA limit set
worst single sample: 1.99 µg/L
78/105 SYR4 2012–2019
Bromoform
1.574 µg/L
No EPA limit set
worst single sample: 1.78 µg/L
73/104 SYR4 2012–2019
Lead
0.0021 mg/L 14%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2023
Lithium
13.6 µg/L
No EPA limit set
 7/10 UCMR-5 2023
Barium
94.55 µg/L 4.7%
of the EPA limit 2000 µg/L
worst single sample: 96.9 µg/L
6/6 SYR4 2012–2019
Fluoride
931.75 µg/L 23%
of the EPA limit 4000 µg/L
worst single sample: 959 µg/L
6/6 SYR4 2012–2019
Copper
21.365 µg/L 1.6%
of the EPA limit 1300 µg/L
worst single sample: 23.3 µg/L
4/6 SYR4 2012–2019
Chromium
1.237 µg/L 1.2%
of the EPA limit 100 µg/L
worst single sample: 1.24 µg/L
3/6 SYR4 2012–2019
Lead
2.26 µg/L 15%
of the EPA limit 15 µg/L
 1/7 SYR4 2012–2019
Nitrate-Nitrite
198 µg/L 2%
of the EPA limit 10000 µg/L
 1/6 SYR4 2012–2019
Selenium
1.6 µg/L 3.2%
of the EPA limit 50 µg/L
 1/6 SYR4 2012–2019
89 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitrateNitritePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Art Garro

Frequently asked questions about Pullman Water Department City of

Is Pullman Water Department City of tap water safe to drink?

EPA monitoring detected 14 contaminants in Pullman Water Department City of's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Pullman Water Department City of's water?

EPA monitoring detected TTHM, Chloroform, Dibromochloromethane, Bromodichloromethane, Bromoform, and others. The full list with the level and data source for each is above.

How many people does Pullman Water Department City of serve?

Pullman Water Department City of reports serving 31,315 people in Washington, per its EPA record.

Has Pullman Water Department City of had any water quality violations?

The EPA has 15 violations on file for Pullman Water Department City of, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.