Tap WaterIndex

← Washington

Tap water quality report

Moxee Water Department

EPA monitoring tested this supplier for 104 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

104
contaminants tested
18
detected
5,599
people served
4
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Local government
Counties served
Yakima

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
89
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2003-09-01 → 2003-09-30
MCL Health-based Archived 1999-02-01 → 1999-02-28
MCL Health-based Archived 1999-02-01 → 1999-02-28
MCL Health-based Archived 1999-02-01 → 1999-02-28
MR Monitoring Resolved 2022-10-01 → 2022-12-31
MR Monitoring Resolved 2022-10-01 → 2022-12-31
MR Monitoring Resolved 2022-10-01 → 2022-12-31
MR Monitoring Resolved 2022-10-01 → 2022-12-31
MR Monitoring Resolved 2022-10-01 → 2022-12-31
MR Monitoring Resolved 2022-10-01 → 2022-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
4.24 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
15/22 SYR4 2012–2019
Chloroform
3.93 µg/L
No EPA limit set
worst single sample: 4.7 µg/L
15/22 SYR4 2012–2019
Dibromochloromethane
5.23 µg/L
No EPA limit set
worst single sample: 5.3 µg/L
15/22 SYR4 2012–2019
TTHM
14.59 µg/L 18%
of the EPA limit 80 µg/L
worst single sample: 16.2 µg/L
15/15 SYR4 2014–2019
Nitrate
110 µg/L 1.1%
of the EPA limit 10000 µg/L
 14/50 SYR4 2012–2019
Bromoform
3.08 µg/L
No EPA limit set
worst single sample: 3.44 µg/L
11/22 SYR4 2012–2019
Lead
0.0022 mg/L 15%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2025
Nitrate-Nitrite
107 µg/L 1.1%
of the EPA limit 10000 µg/L
worst single sample: 110 µg/L
7/25 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
2.3 µg/L 3.8%
of the EPA limit 60 µg/L
worst single sample: 2.4 µg/L
6/10 SYR4 2014–2018
Trichloroacetic Acid
2.3 µg/L
No EPA limit set
worst single sample: 2.4 µg/L
6/12 SYR4 2014–2019
Lithium
22.1 µg/L
No EPA limit set
 6/6 UCMR-5 2024
Barium
3.265 µg/L 0.2%
of the EPA limit 2000 µg/L
worst single sample: 3.37 µg/L
4/4 SYR4 2015–2016
Copper
1.195 µg/L 0.1%
of the EPA limit 1300 µg/L
worst single sample: 1.24 µg/L
4/4 SYR4 2015–2016
Fluoride
1545.5 µg/L 39%
of the EPA limit 4000 µg/L
worst single sample: 1610 µg/L
4/4 SYR4 2015–2016
Thallium, Total
0.3525 µg/L 18%
of the EPA limit 2 µg/L
worst single sample: 0.3600 µg/L
4/4 SYR4 2015–2016
Arsenic
3.235 µg/L 32%
of the EPA limit 10 µg/L
worst single sample: 3.29 µg/L
3/4 SYR4 2015–2016
Chromium
0.1870 µg/L 0.2%
of the EPA limit 100 µg/L
worst single sample: 0.1900 µg/L
2/4 SYR4 2015–2016
Lead
0.6465 µg/L 4.3%
of the EPA limit 15 µg/L
worst single sample: 0.6600 µg/L
2/4 SYR4 2015–2016
86 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebEthylene DibromideEndrinEthylbenzeneHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNetfosaaNfdhaNmefosaaNitritePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Byron Adams

Frequently asked questions about Moxee Water Department

Is Moxee Water Department tap water safe to drink?

EPA monitoring detected 18 contaminants in Moxee Water Department's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Moxee Water Department's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, Nitrate, and others. The full list with the level and data source for each is above.

How many people does Moxee Water Department serve?

Moxee Water Department reports serving 5,599 people in Washington, per its EPA record.

Has Moxee Water Department had any water quality violations?

The EPA has 89 violations on file for Moxee Water Department, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.