Tap WaterIndex

← Washington

Tap water quality report

Pebble Ridge

EPA monitoring tested this supplier for 70 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

70
contaminants tested
9
detected
106
people served
5
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Private
Counties served
Kitsap

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

5
health-based violations
35
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2005-06-01 → 2005-06-30
MCL Health-based Archived 2005-04-01 → 2005-04-30
MCL Health-based Archived 1997-01-01 → 1997-01-31
MCL Health-based Archived 1997-01-01 → 1997-01-31
MCL Health-based Archived 1997-01-01 → 1997-01-31
MR Monitoring Resolved 2020-01-01 → 2020-12-31
MR Monitoring Resolved 2012-01-01
MR Monitoring Resolved 2008-01-01 → 2010-12-31
MR Monitoring Resolved 2008-01-01 → 2010-12-31
MR Monitoring Resolved 2008-01-01 → 2010-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
900 µg/L 9%
of the EPA limit 10000 µg/L
 18/18 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2024
Bromodichloromethane
1.1 µg/L
No EPA limit set
 1/4 SYR4 2012–2017
Chloroform
2 µg/L
No EPA limit set
 1/5 SYR4 2012–2017
Dibromochloromethane
0.6000 µg/L
No EPA limit set
 1/4 SYR4 2012–2017
Dichloroacetic Acid
1.4 µg/L
No EPA limit set
 1/4 SYR4 2012–2017
Nitrate-Nitrite
570 µg/L 5.7%
of the EPA limit 10000 µg/L
 1/1 SYR4 2013
TTHM
3.7 µg/L 4.6%
of the EPA limit 80 µg/L
 1/1 SYR4 2013
Total Haloacetic Acids (HAA5)
1.4 µg/L 2.3%
of the EPA limit 60 µg/L
 1/4 SYR4 2012–2017
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebEndrinEthylbenzeneFluorideHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Kevin Odegard

Frequently asked questions about Pebble Ridge

Is Pebble Ridge tap water safe to drink?

EPA monitoring detected 9 contaminants in Pebble Ridge's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Pebble Ridge's water?

EPA monitoring detected Nitrate, Lead, Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Pebble Ridge serve?

Pebble Ridge reports serving 106 people in Washington, per its EPA record.

Has Pebble Ridge had any water quality violations?

The EPA has 35 violations on file for Pebble Ridge, of which 5 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.