Tap WaterIndex

← Washington

Tap water quality report

Freeland Water and Sewer District

EPA monitoring tested this supplier for 71 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
16
detected
1,264
people served
0
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Local government
Counties served
Island

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
92
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2025-07-01
MR Monitoring Archived 2025-01-01 → 2025-12-31
MR Monitoring Resolved 2021-01-01 → 2021-12-31
MR Monitoring Resolved 2017-01-01 → 2017-12-31
MR Monitoring Resolved 2017-01-01 → 2017-12-31
MON Monitoring Resolved 2017-01-01 → 2017-01-31
MR Monitoring Resolved 2016-01-01 → 2016-12-31
MR Monitoring Resolved 2016-01-01 → 2016-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31
MR Monitoring Resolved 2015-01-01 → 2015-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
4667.5 µg/L 47%
of the EPA limit 10000 µg/L
worst single sample: 4750 µg/L
32/40 SYR4 2012–2018
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2023
Bromodichloromethane
10.35 µg/L
No EPA limit set
worst single sample: 12.5 µg/L
11/11 SYR4 2012–2019
Bromoform
6.65 µg/L
No EPA limit set
worst single sample: 7.9 µg/L
11/11 SYR4 2012–2019
Chloroform
6.55 µg/L
No EPA limit set
worst single sample: 7.6 µg/L
11/11 SYR4 2012–2019
Dibromochloromethane
14 µg/L
No EPA limit set
worst single sample: 14.6 µg/L
11/11 SYR4 2012–2019
TTHM
33.85 µg/L 42%
of the EPA limit 80 µg/L
worst single sample: 37.8 µg/L
11/11 SYR4 2012–2019
Dibromoacetic Acid
3.81 µg/L
No EPA limit set
worst single sample: 3.9 µg/L
7/8 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
8.08 µg/L 13%
of the EPA limit 60 µg/L
worst single sample: 8.2 µg/L
7/8 SYR4 2012–2019
Dichloroacetic Acid
2.775 µg/L
No EPA limit set
worst single sample: 3 µg/L
6/7 SYR4 2012–2019
Trichloroacetic Acid
3.65 µg/L
No EPA limit set
worst single sample: 4 µg/L
6/8 SYR4 2012–2019
Arsenic
4.16 µg/L 42%
of the EPA limit 10 µg/L
worst single sample: 4.3 µg/L
5/5 SYR4 2012–2017
Nitrate-Nitrite
4260 µg/L 43%
of the EPA limit 10000 µg/L
worst single sample: 4600 µg/L
5/5 SYR4 2012–2017
Monobromoacetic Acid
1.58 µg/L
No EPA limit set
worst single sample: 1.6 µg/L
3/7 SYR4 2012–2019
Copper
200 µg/L 15%
of the EPA limit 1300 µg/L
 2/6 SYR4 2012–2017
Fluoride
594 µg/L 15%
of the EPA limit 4000 µg/L
worst single sample: 600 µg/L
2/5 SYR4 2012–2017
55 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Andrew Campbell

Frequently asked questions about Freeland Water and Sewer District

Is Freeland Water and Sewer District tap water safe to drink?

EPA monitoring detected 16 contaminants in Freeland Water and Sewer District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Freeland Water and Sewer District's water?

EPA monitoring detected Nitrate, Lead, Bromodichloromethane, Bromoform, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Freeland Water and Sewer District serve?

Freeland Water and Sewer District reports serving 1,264 people in Washington, per its EPA record.

Has Freeland Water and Sewer District had any water quality violations?

The EPA has 92 violations on file for Freeland Water and Sewer District, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.