Tap WaterIndex

← Washington

Tap water quality report

Graham Place

EPA monitoring tested this supplier for 71 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

71
contaminants tested
10
detected
41
people served
5
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Private
Counties served
Kitsap

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

5
health-based violations
1,070
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1995-09-01 → 1995-09-30
MCL Health-based Archived 1994-04-01 → 1994-04-30
MCL Health-based Archived 1992-07-01 → 1992-07-31
MCL Health-based Archived 1992-07-01 → 1992-07-31
MCL Health-based Archived 1992-07-01 → 1992-07-31
Other Monitoring Resolved 2023-07-01
MON Monitoring Resolved 2022-11-01 → 2022-11-30
MON Monitoring Resolved 2021-09-01 → 2021-09-30
MR Monitoring Resolved 2007-01-01 → 2007-03-31
MR Monitoring Resolved 2007-01-01 → 2007-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
1000 µg/L 10%
of the EPA limit 10000 µg/L
 24/24 SYR4 2013–2019
Lead
0.0023 mg/L 15%
of the EPA limit 0.0150 mg/L
 9/9 LCR 2024
Chloroform
1.9 µg/L
No EPA limit set
 4/4 SYR4 2014–2017
Arsenic
2.4 µg/L 24%
of the EPA limit 10 µg/L
 2/2 SYR4 2013
Bromodichloromethane
1.77 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
2/2 SYR4 2014–2017
Dibromochloromethane
1.169 µg/L
No EPA limit set
worst single sample: 1.2 µg/L
2/2 SYR4 2014–2017
Nitrate-Nitrite
740 µg/L 7.4%
of the EPA limit 10000 µg/L
 2/2 SYR4 2013
TTHM
4.824 µg/L 6%
of the EPA limit 80 µg/L
worst single sample: 4.9 µg/L
2/2 SYR4 2014–2017
Dichloroacetic Acid
1.3 µg/L
No EPA limit set
 1/2 SYR4 2014–2017
Total Haloacetic Acids (HAA5)
1.3 µg/L 2.2%
of the EPA limit 60 µg/L
 1/2 SYR4 2014–2017
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebEndrinEthylbenzeneFluorideHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Kevin Odegard

Frequently asked questions about Graham Place

Is Graham Place tap water safe to drink?

EPA monitoring detected 10 contaminants in Graham Place's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Graham Place's water?

EPA monitoring detected Nitrate, Lead, Chloroform, Arsenic, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Graham Place serve?

Graham Place reports serving 41 people in Washington, per its EPA record.

Has Graham Place had any water quality violations?

The EPA has 1070 violations on file for Graham Place, of which 5 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.