Tap WaterIndex

← Washington

Tap water quality report

Sandberg Water Assn

EPA monitoring tested this supplier for 50 contaminants and detected 3. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
3
detected
37
people served
0
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Private
Counties served
Island

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
48
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2025-07-01
Other Monitoring Resolved 2016-07-01
Other Monitoring Resolved 2013-07-01
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31
MR Monitoring Resolved 2007-01-01 → 2007-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 10/10 LCR 2025
Nitrate
240 µg/L 2.4%
of the EPA limit 10000 µg/L
 2/8 SYR4 2012–2018
Arsenic
7.5 µg/L 75%
of the EPA limit 10 µg/L
 1/1 SYR4 2013
47 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalBariumBenzeneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChloroformChromiumDichloromethaneDalaponDibromochloromethaneDinosebEthylene DibromideEthylbenzeneFluorideLeadMercuryNitrate-NitriteNitritePentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Andrew Campbell

Frequently asked questions about Sandberg Water Assn

Is Sandberg Water Assn tap water safe to drink?

EPA monitoring detected 3 contaminants in Sandberg Water Assn's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Sandberg Water Assn's water?

EPA monitoring detected Lead, Nitrate, Arsenic. The full list with the level and data source for each is above.

How many people does Sandberg Water Assn serve?

Sandberg Water Assn reports serving 37 people in Washington, per its EPA record.

Has Sandberg Water Assn had any water quality violations?

The EPA has 48 violations on file for Sandberg Water Assn, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.