← Washington

Tap water quality report

Chelan Falls Water District

EPA monitoring tested this supplier for 55 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

55
contaminants tested
12
detected
335
people served
2
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Chelan

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

2
health-based violations
36
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 1993-07-01 → 1993-07-31
MCL Health-based Archived 1992-11-01 → 1992-11-30
MON Monitoring Resolved 2018-07-01 → 2018-07-31
Other Monitoring Resolved 2012-07-01
MR Monitoring Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2002-01-01 → 2004-12-31
MR Monitoring Resolved 2002-01-01 → 2004-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.00050 mg/L 3.3%
of the EPA limit 0.0150 mg/L
13/13 LCR 2024
Nitrate
4000 µg/L 40%
of the EPA limit 10000 µg/L
12/14 SYR4 2012–2019
Nitrate-Nitrite
3685 µg/L 37%
of the EPA limit 10000 µg/L
worst single sample: 4000 µg/L
6/7 SYR4 2012–2019
Chloroform
2.455 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
4/5 SYR4 2013–2017
TTHM
3.54 µg/L 4.4%
of the EPA limit 80 µg/L
worst single sample: 3.6 µg/L
4/4 SYR4 2013–2017
Dichloroacetic Acid
1.39 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
3/4 SYR4 2013–2017
Total Haloacetic Acids (HAA5)
2.49 µg/L 4.2%
of the EPA limit 60 µg/L
worst single sample: 2.5 µg/L
3/4 SYR4 2013–2017
Bromodichloromethane
1.095 µg/L
No EPA limit set
worst single sample: 1.1 µg/L
2/5 SYR4 2013–2017
Trichloroacetic Acid
1.1 µg/L
No EPA limit set
2/4 SYR4 2013–2017
Barium
24 µg/L 1.2%
of the EPA limit 2000 µg/L
1/1 SYR4 2014
Copper
5.4 µg/L 0.4%
of the EPA limit 1300 µg/L
1/1 SYR4 2014
Fluoride
70 µg/L 1.8%
of the EPA limit 4000 µg/L
1/1 SYR4 2014
43 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicBenzeneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDalaponDibromoacetic AcidDibromochloromethaneDinosebEthylbenzeneLeadMercuryMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Ron Slabaugh

Frequently asked questions about Chelan Falls Water District

Is Chelan Falls Water District tap water safe to drink?

EPA monitoring detected 12 contaminants in Chelan Falls Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Chelan Falls Water District's water?

EPA monitoring detected Lead, Nitrate, Nitrate-Nitrite, Chloroform, TTHM, and others. The full list with the level and data source for each is above.

How many people does Chelan Falls Water District serve?

Chelan Falls Water District reports serving 335 people in Washington, per its EPA record.

Has Chelan Falls Water District had any water quality violations?

The EPA has 36 violations on file for Chelan Falls Water District, of which 2 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.