Tap WaterIndex

← Washington

Tap water quality report

Camelot Subdivision

EPA monitoring tested this supplier for 73 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

73
contaminants tested
12
detected
142
people served
0
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Local government
Counties served
Cowlitz

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
13
violations on file
0
still open
ViolationTypeStatusPeriod
Other Monitoring Resolved 2024-07-01
Other Monitoring Resolved 2020-07-01
Other Monitoring Resolved 2014-07-01
MR Monitoring Archived 2003-11-01 → 2003-11-30
MR Monitoring Archived 1979-10-01 → 1979-10-31
MR Monitoring Archived 1979-10-01 → 1979-10-31
MR Monitoring Archived 1979-10-01 → 1979-10-31
MR Monitoring Archived 1979-10-01 → 1979-10-31
MR Monitoring Archived 1979-10-01 → 1979-10-31
MR Monitoring Archived 1979-10-01 → 1979-10-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
1160 µg/L 12%
of the EPA limit 10000 µg/L
 18/18 SYR4 2012–2019
Lead
0.0015 mg/L 10%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2025
Bromodichloromethane
1.92 µg/L
No EPA limit set
worst single sample: 2 µg/L
5/5 SYR4 2012–2018
Dibromochloromethane
2.44 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
5/5 SYR4 2012–2018
TTHM
6.696 µg/L 8.4%
of the EPA limit 80 µg/L
worst single sample: 6.9 µg/L
5/5 SYR4 2012–2018
Bromoform
1.085 µg/L
No EPA limit set
worst single sample: 1.1 µg/L
4/5 SYR4 2012–2018
Chloroform
1.358 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
3/5 SYR4 2012–2018
Nitrate-Nitrite
1030.5 µg/L 10%
of the EPA limit 10000 µg/L
worst single sample: 1070 µg/L
2/2 SYR4 2017–2018
Chromium
1 µg/L 1%
of the EPA limit 100 µg/L
 1/1 SYR4 2018
Dibromoacetic Acid
1.4 µg/L
No EPA limit set
 1/3 SYR4 2013–2017
Dichloroacetic Acid
1.7 µg/L
No EPA limit set
 1/3 SYR4 2013–2017
Total Haloacetic Acids (HAA5)
3.1 µg/L 5.2%
of the EPA limit 60 µg/L
 1/3 SYR4 2013–2017
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinEthylbenzeneFluorideHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoLeadMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Susan Eugenis

Frequently asked questions about Camelot Subdivision

Is Camelot Subdivision tap water safe to drink?

EPA monitoring detected 12 contaminants in Camelot Subdivision's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Camelot Subdivision's water?

EPA monitoring detected Nitrate, Lead, Bromodichloromethane, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Camelot Subdivision serve?

Camelot Subdivision reports serving 142 people in Washington, per its EPA record.

Has Camelot Subdivision had any water quality violations?

The EPA has 13 violations on file for Camelot Subdivision, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.