← Washington

Tap water quality report

Boots & Saddles 662

EPA monitoring tested this supplier for 55 contaminants and detected 1. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

55
contaminants tested
1
detected
150
people served
3
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Pierce

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
60
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2003-10-01 → 2003-10-31
MCL Health-based Archived 1993-03-01 → 1993-03-31
MCL Health-based Archived 1993-01-01 → 1993-01-31
MR Monitoring Archived 2018-01-01 → 2020-12-31
MR Monitoring Archived 2018-01-01 → 2020-12-31
MR Monitoring Resolved 2015-12-01 → 2015-12-31
MR Monitoring Resolved 2015-12-01 → 2015-12-31
MR Monitoring Resolved 2015-12-01 → 2015-12-31
MR Monitoring Resolved 2010-01-01 → 2010-12-31
MR Monitoring Resolved 2008-01-01 → 2010-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0200 mg/L 133%
above the EPA limit of 0.0150 mg/L
11/11 LCR 2024
54 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAtrazineBhc-GammaBenzeneBenzo(A)PyreneBromodichloromethaneBromoformChlorobenzeneCarbon TetrachlorideChlordaneChloroformDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDibromochloromethaneDichloroacetic AcidDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitratePentachlorophenolPicloramSimazineStyreneTetrachloroethyleneTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Kimberly Gubbe

Frequently asked questions about Boots & Saddles 662

Is Boots & Saddles 662 tap water safe to drink?

EPA monitoring detected 1 contaminant in Boots & Saddles 662's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Boots & Saddles 662's water?

EPA monitoring detected Lead. The full list with the level and data source for each is above.

How many people does Boots & Saddles 662 serve?

Boots & Saddles 662 reports serving 150 people in Washington, per its EPA record.

Has Boots & Saddles 662 had any water quality violations?

The EPA has 60 violations on file for Boots & Saddles 662, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.