Tap WaterIndex

← Washington

Tap water quality report

Bayview Beach Water District

EPA monitoring tested this supplier for 57 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

57
contaminants tested
18
detected
1,035
people served
24
health-based violations
Washington rankingsLead in WashingtonPFAS in Washington
Water source
Ground water
Ownership
Local government
Counties served
Island

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

24
health-based violations
36
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2006-10-01 → 2006-10-31
MCL Health-based Archived 2005-10-01 → 2005-10-31
MCL Health-based Archived 2003-09-01 → 2003-09-30
MCL Health-based Archived 2000-10-01 → 2000-10-31
MCL Health-based Archived 2000-10-01 → 2000-10-31
MCL Health-based Archived 2000-10-01 → 2000-10-31
MCL Health-based Archived 1998-08-01 → 1998-08-31
MCL Health-based Archived 1998-08-01 → 1998-08-31
MCL Health-based Archived 1998-08-01 → 1998-08-31
MCL Health-based Archived 1998-07-01 → 1998-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
8.5 µg/L
No EPA limit set
worst single sample: 12.4 µg/L
16/18 SYR4 2012–2019
TTHM
32.95 µg/L 41%
of the EPA limit 80 µg/L
worst single sample: 36.4 µg/L
16/16 SYR4 2012–2019
Bromoform
13.53 µg/L
No EPA limit set
worst single sample: 17.8 µg/L
15/18 SYR4 2012–2019
Dibromochloromethane
13.66 µg/L
No EPA limit set
worst single sample: 14.5 µg/L
15/18 SYR4 2012–2019
Lead
0.0015 mg/L 10%
of the EPA limit 0.0150 mg/L
 15/15 LCR 2025
Nitrate
860 µg/L 8.6%
of the EPA limit 10000 µg/L
 14/16 SYR4 2013–2019
Chloroform
4.78 µg/L
No EPA limit set
worst single sample: 6.4 µg/L
13/17 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
11.04 µg/L 18%
of the EPA limit 60 µg/L
worst single sample: 12.3 µg/L
8/14 SYR4 2012–2019
Dibromoacetic Acid
8.275 µg/L
No EPA limit set
worst single sample: 9.4 µg/L
6/14 SYR4 2012–2019
Dichloroacetic Acid
3.005 µg/L
No EPA limit set
worst single sample: 3.2 µg/L
4/14 SYR4 2012–2019
Trichloroacetic Acid
1.825 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
4/14 SYR4 2012–2019
Arsenic
5.63 µg/L 56%
of the EPA limit 10 µg/L
worst single sample: 5.8 µg/L
2/2 SYR4 2019
Barium
32.67 µg/L 1.6%
of the EPA limit 2000 µg/L
worst single sample: 33.2 µg/L
2/2 SYR4 2019
Monobromoacetic Acid
1.495 µg/L
No EPA limit set
worst single sample: 1.5 µg/L
2/14 SYR4 2012–2019
Nitrate-Nitrite
855 µg/L 8.6%
of the EPA limit 10000 µg/L
worst single sample: 860 µg/L
2/2 SYR4 2019
Copper
29.1 µg/L 2.2%
of the EPA limit 1300 µg/L
 1/2 SYR4 2019
Chromium
1.4 µg/L 1.4%
of the EPA limit 100 µg/L
 1/2 SYR4 2019
Fluoride
110 µg/L 2.8%
of the EPA limit 4000 µg/L
 1/2 SYR4 2019
39 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAsbestosBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideDichloromethaneDalaponDinosebEthylbenzeneGross Beta Particle ActivityLeadMercuryMonochloroacetic AcidNitritePentachlorophenolPicloramSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Andrew Campbell

Frequently asked questions about Bayview Beach Water District

Is Bayview Beach Water District tap water safe to drink?

EPA monitoring detected 18 contaminants in Bayview Beach Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bayview Beach Water District's water?

EPA monitoring detected Bromodichloromethane, TTHM, Bromoform, Dibromochloromethane, Lead, and others. The full list with the level and data source for each is above.

How many people does Bayview Beach Water District serve?

Bayview Beach Water District reports serving 1,035 people in Washington, per its EPA record.

Has Bayview Beach Water District had any water quality violations?

The EPA has 36 violations on file for Bayview Beach Water District, of which 24 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.