← Washington

Tap water quality report

Artesian Water District 8

EPA monitoring tested this supplier for 67 contaminants and detected 6. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

67
contaminants tested
6
detected
302
people served
1
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Walla Walla

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

1
health-based violations
49
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2004-09-01 → 2004-09-30
Other Monitoring Resolved 2025-07-01
MON Monitoring Resolved 2023-11-01 → 2023-11-30
MR Monitoring Resolved 2021-01-01
MR Monitoring Archived 2020-01-01 → 2025-12-31
MR Monitoring Archived 2020-01-01 → 2025-12-31
MR Monitoring Archived 2020-01-01 → 2025-12-31
MR Monitoring Archived 2020-01-01 → 2025-12-31
MR Monitoring Archived 2020-01-01 → 2025-12-31
MR Monitoring Archived 2020-01-01 → 2025-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Lead
0.0015 mg/L 10%
of the EPA limit 0.0150 mg/L
9/9 LCR 2024
Nitrate
500 µg/L 5%
of the EPA limit 10000 µg/L
8/18 SYR4 2012–2019
Barium
31 µg/L 1.6%
of the EPA limit 2000 µg/L
1/1 SYR4 2018
Fluoride
630 µg/L 16%
of the EPA limit 4000 µg/L
1/1 SYR4 2018
Lead
5 µg/L 33%
of the EPA limit 15 µg/L
1/1 SYR4 2018
Nitrate-Nitrite
130 µg/L 1.3%
of the EPA limit 10000 µg/L
1/1 SYR4 2018
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromodichloromethaneBromoformChlorobenzeneCopperCyanideCadmiumCarbon TetrachlorideChlordaneChloroformChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromochloromethaneDinosebEthylene DibromideEndrinEthylbenzeneGross Beta Particle ActivityHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitritePentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Dennis Anderson

Frequently asked questions about Artesian Water District 8

Is Artesian Water District 8 tap water safe to drink?

EPA monitoring detected 6 contaminants in Artesian Water District 8's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Artesian Water District 8's water?

EPA monitoring detected Lead, Nitrate, Barium, Fluoride, Lead, and others. The full list with the level and data source for each is above.

How many people does Artesian Water District 8 serve?

Artesian Water District 8 reports serving 302 people in Washington, per its EPA record.

Has Artesian Water District 8 had any water quality violations?

The EPA has 49 violations on file for Artesian Water District 8, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.