← Vermont

Tap water quality report

Solitude Water

EPA monitoring tested this supplier for 47 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

47
contaminants tested
10
detected
976
people served
0
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Windsor

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
14
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2019-10-01
MR Monitoring Resolved 2006-10-01
MR Monitoring Resolved 2006-10-01
MR Monitoring Resolved 2006-10-01
MR Monitoring Resolved 2006-10-01
MR Monitoring Archived 2000-01-01 → 2000-03-31
MR Monitoring Resolved 2000-01-01 → 2000-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
155.5 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 200 µg/L
28/30 SYR4 2013–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
14/14 LCR 2026
Nitrate
200 µg/L 2%
of the EPA limit 10000 µg/L
12/16 SYR4 2012–2019
Lead
4 µg/L 27%
of the EPA limit 15 µg/L
8/30 SYR4 2013–2019
Bromodichloromethane
2.17 µg/L
No EPA limit set
worst single sample: 2.5 µg/L
7/9 SYR4 2012–2019
Chloroform
4.47 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
7/9 SYR4 2012–2019
TTHM
8.725 µg/L 11%
of the EPA limit 80 µg/L
worst single sample: 9.8 µg/L
6/7 SYR4 2012–2019
Dibromochloromethane
1.75 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
4/9 SYR4 2012–2019
Bromoform
0.6000 µg/L
No EPA limit set
1/9 SYR4 2012–2019
Combined Radium (-226 And -228)
0.2000 pCi/L 4%
of the EPA limit 5 pCi/L
1/1 SYR4 2012
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBariumBenzeneBeryllium, TotalChlorobenzeneCadmiumCarbon TetrachlorideChromiumDichloromethaneDibromoacetic AcidDichloroacetic AcidEthylbenzeneFluorideMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
NORMYLE, MICHAEL
Phone
802-558-4227
Email
[email protected]

Frequently asked questions about Solitude Water

Is Solitude Water tap water safe to drink?

EPA monitoring detected 10 contaminants in Solitude Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Solitude Water's water?

EPA monitoring detected Copper, Lead, Nitrate, Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Solitude Water serve?

Solitude Water reports serving 976 people in Vermont, per its EPA record.

Has Solitude Water had any water quality violations?

The EPA has 14 violations on file for Solitude Water, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.