← Vermont

Tap water quality report

Winterplace Water

EPA monitoring tested this supplier for 48 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

48
contaminants tested
13
detected
700
people served
13
health-based violations
Water source
Ground water
Ownership
Private
Counties served
Windsor

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

13
health-based violations
107
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 2006-10-01 → 2006-10-31
MCL Health-based Resolved 1994-07-01 → 1994-07-31
MCL Health-based Resolved 1994-07-01 → 1994-07-31
MCL Health-based Resolved 1994-07-01 → 1994-07-31
MCL Health-based Resolved 1992-06-01 → 1992-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
539 µg/L 41%
of the EPA limit 1300 µg/L
worst single sample: 2600 µg/L
144/182 SYR4 2012–2019
Lead
51.105 µg/L 341%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 420 µg/L
62/182 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
26/26 LCR 2025
Nitrate
400 µg/L 4%
of the EPA limit 10000 µg/L
10/16 SYR4 2012–2019
Bromodichloromethane
3.98 µg/L
No EPA limit set
worst single sample: 4.4 µg/L
8/8 SYR4 2012–2019
Chloroform
2.65 µg/L
No EPA limit set
worst single sample: 3 µg/L
8/8 SYR4 2012–2019
Dibromochloromethane
4.765 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
8/8 SYR4 2012–2019
Bromoform
2.31 µg/L
No EPA limit set
worst single sample: 2.4 µg/L
7/8 SYR4 2012–2019
TTHM
13.35 µg/L 17%
of the EPA limit 80 µg/L
worst single sample: 14 µg/L
6/6 SYR4 2012–2019
Barium
34 µg/L 1.7%
of the EPA limit 2000 µg/L
1/1 SYR4 2014
Combined Radium (-226 And -228)
0.6710 pCi/L 13%
of the EPA limit 5 pCi/L
1/1 SYR4 2018
Dibromoacetic Acid
1.8 µg/L
No EPA limit set
1/6 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
1.8 µg/L 3%
of the EPA limit 60 µg/L
1/6 SYR4 2012–2019
35 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDichloroacetic AcidEthylbenzeneFluorideMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WATANABE, JOHN
Phone
802-228-4934
Email
[email protected]

Frequently asked questions about Winterplace Water

Is Winterplace Water tap water safe to drink?

EPA monitoring detected 13 contaminants in Winterplace Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Winterplace Water's water?

EPA monitoring detected Copper, Lead, Lead, Nitrate, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Winterplace Water serve?

Winterplace Water reports serving 700 people in Vermont, per its EPA record.

Has Winterplace Water had any water quality violations?

The EPA has 107 violations on file for Winterplace Water, of which 13 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.