Tap WaterIndex

← Vermont

Tap water quality report

St George Fire District #2

EPA monitoring tested this supplier for 50 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

50
contaminants tested
13
detected
72
people served
55
health-based violations
Vermont rankingsLead in VermontPFAS in Vermont
Water source
Ground water
Ownership
Private
Counties served
Chittenden

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

55
health-based violations
77
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2010-12-16
TT Health-based Resolved 2010-12-16
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
390 µg/L 3.9%
of the EPA limit 10000 µg/L
 16/16 SYR4 2012–2019
Lead
0.0033 mg/L 22%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2024
Copper
120 µg/L 9.2%
of the EPA limit 1300 µg/L
worst single sample: 130 µg/L
11/15 SYR4 2012–2018
Combined Radium (-226 And -228)
4.668 pCi/L 93%
of the EPA limit 5 pCi/L
worst single sample: 4.99 pCi/L
8/8 SYR4 2012–2019
Lead
7.575 µg/L 51%
of the EPA limit 15 µg/L
worst single sample: 9.5 µg/L
8/15 SYR4 2012–2018
Bromodichloromethane
2.425 µg/L
No EPA limit set
worst single sample: 2.7 µg/L
6/6 SYR4 2013–2019
Chloroform
2.625 µg/L
No EPA limit set
worst single sample: 3 µg/L
6/6 SYR4 2013–2019
Dibromochloromethane
2.4 µg/L
No EPA limit set
worst single sample: 2.6 µg/L
6/6 SYR4 2013–2019
Bromoform
0.7000 µg/L
No EPA limit set
 4/6 SYR4 2013–2019
TTHM
8.59 µg/L 11%
of the EPA limit 80 µg/L
worst single sample: 9 µg/L
3/3 SYR4 2013–2017
Combined Uranium
6.269 µg/L 21%
of the EPA limit 30 µg/L
worst single sample: 6.3 µg/L
2/2 SYR4 2014–2017
Gross Alpha, Excl. Radon And U
6.2505 pCi/L 42%
of the EPA limit 15 pCi/L
worst single sample: 6.39 pCi/L
2/2 SYR4 2014–2017
Barium
130 µg/L 6.5%
of the EPA limit 2000 µg/L
 1/1 SYR4 2014
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneDibromoacetic AcidDichloroacetic AcidEthylbenzeneFluorideMercuryMonobromoacetic AcidMonochloroacetic AcidSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
CLELAND, JAYMI
Phone
802-829-0751
Email
[email protected]

Frequently asked questions about St George Fire District #2

Is St George Fire District #2 tap water safe to drink?

EPA monitoring detected 13 contaminants in St George Fire District #2's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in St George Fire District #2's water?

EPA monitoring detected Nitrate, Lead, Copper, Combined Radium (-226 And -228), Lead, and others. The full list with the level and data source for each is above.

How many people does St George Fire District #2 serve?

St George Fire District #2 reports serving 72 people in Vermont, per its EPA record.

Has St George Fire District #2 had any water quality violations?

The EPA has 77 violations on file for St George Fire District #2, of which 55 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.