Tap WaterIndex

← Vermont

Tap water quality report

St George Fire District 1

EPA monitoring tested this supplier for 41 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

41
contaminants tested
12
detected
42
people served
28
health-based violations
Vermont rankingsLead in VermontPFAS in Vermont
Water source
Ground water
Ownership
Local government
Counties served
Chittenden

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

28
health-based violations
59
violations on file
3
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2004-11-01 → 2004-11-30
MCL Health-based Resolved 2004-11-01 → 2004-11-30
MCL Health-based Resolved 2004-11-01 → 2004-11-30
MCL Health-based Resolved 2004-11-01 → 2004-11-30
MCL Health-based Resolved 2004-11-01 → 2004-11-30
MCL Health-based Resolved 2004-07-01 → 2004-07-31
MCL Health-based Resolved 2004-07-01 → 2004-07-31
MCL Health-based Resolved 2004-07-01 → 2004-07-31
MCL Health-based Resolved 2004-07-01 → 2004-07-31
MCL Health-based Resolved 2003-06-01 → 2003-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Dibromochloromethane
1.49 µg/L
No EPA limit set
worst single sample: 1.8 µg/L
22/22 SYR4 2012–2018
Bromodichloromethane
1.3 µg/L
No EPA limit set
worst single sample: 2.1 µg/L
21/22 SYR4 2012–2018
Chloroform
1.05 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
18/22 SYR4 2012–2018
Nitrate
120 µg/L 1.2%
of the EPA limit 10000 µg/L
 16/16 SYR4 2012–2019
Lead
0.0026 mg/L 17%
of the EPA limit 0.0150 mg/L
 13/13 LCR 2025
Copper
46 µg/L 3.5%
of the EPA limit 1300 µg/L
worst single sample: 47 µg/L
11/15 SYR4 2013–2019
Lead
10.435 µg/L 70%
of the EPA limit 15 µg/L
worst single sample: 13.9 µg/L
8/15 SYR4 2013–2019
trans-1,2-Dichloroethylene
0.8000 µg/L 0.8%
of the EPA limit 100 µg/L
 3/20 SYR4 2012–2018
Bromoform
0.8800 µg/L
No EPA limit set
worst single sample: 0.9000 µg/L
2/22 SYR4 2012–2018
TTHM
5.64 µg/L 7%
of the EPA limit 80 µg/L
worst single sample: 5.8 µg/L
2/3 SYR4 2014–2017
Combined Uranium
4.6 µg/L 15%
of the EPA limit 30 µg/L
 1/1 SYR4 2019
Gross Alpha, Excl. Radon And U
6.68 pCi/L 45%
of the EPA limit 15 pCi/L
 1/1 SYR4 2019
29 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-DichloropropaneAsbestosBenzeneChlorobenzeneCarbon TetrachlorideDichloromethaneDibromoacetic AcidDichloroacetic AcidEthylene DibromideEthylbenzeneMonobromoacetic AcidMonochloroacetic AcidStyreneTetrachloroethyleneTolueneTotal Haloacetic Acids (HAA5)Trichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzene

Utility contact

Contact
GONYAW, WILLIAM
Phone
802-324-2894

Frequently asked questions about St George Fire District 1

Is St George Fire District 1 tap water safe to drink?

EPA monitoring detected 12 contaminants in St George Fire District 1's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in St George Fire District 1's water?

EPA monitoring detected Dibromochloromethane, Bromodichloromethane, Chloroform, Nitrate, Lead, and others. The full list with the level and data source for each is above.

How many people does St George Fire District 1 serve?

St George Fire District 1 reports serving 42 people in Vermont, per its EPA record.

Has St George Fire District 1 had any water quality violations?

The EPA has 59 violations on file for St George Fire District 1, of which 28 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.