← Virginia

Tap water quality report

N a S Oceana

EPA monitoring tested this supplier for 44 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

44
contaminants tested
11
detected
7,300
people served
18
health-based violations
Water source
SWP
Ownership
Federal government

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

18
health-based violations
20
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2007-09-01 → 2007-09-30
MCL Health-based Resolved 2007-09-01 → 2007-09-30
MCL Health-based Resolved 2007-09-01 → 2007-09-30
MCL Health-based Resolved 2007-09-01 → 2007-09-30
MCL Health-based Resolved 2006-12-01 → 2006-12-31
MCL Health-based Resolved 2006-12-01 → 2006-12-31
MCL Health-based Resolved 2006-12-01 → 2006-12-31
MCL Health-based Resolved 2006-12-01 → 2006-12-31
MCL Health-based Resolved 2006-07-01 → 2006-07-31
MCL Health-based Resolved 2006-07-01 → 2006-07-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
58.42 µg/L 73%
of the EPA limit 80 µg/L
worst single sample: 62.6 µg/L
73/73 SYR4 2012–2019
Chloroform
51.085 µg/L
No EPA limit set
worst single sample: 54 µg/L
64/64 SYR4 2012–2019
Bromodichloromethane
10.28 µg/L
No EPA limit set
worst single sample: 11.1 µg/L
62/62 SYR4 2012–2019
Copper
138.3 µg/L 11%
of the EPA limit 1300 µg/L
worst single sample: 310 µg/L
59/59 SYR4 2012–2018
Dibromochloromethane
1.93 µg/L
No EPA limit set
worst single sample: 2.7 µg/L
55/58 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
48.35 µg/L 81%
of the EPA limit 60 µg/L
worst single sample: 58 µg/L
54/63 SYR4 2012–2019
Dichloroacetic Acid
29 µg/L
No EPA limit set
worst single sample: 30 µg/L
38/42 SYR4 2014–2019
Trichloroacetic Acid
24 µg/L
No EPA limit set
worst single sample: 26 µg/L
36/42 SYR4 2014–2019
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
13/13 LCR 2024
Lead
18 µg/L 120%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 32 µg/L
11/59 SYR4 2012–2018
Monochloroacetic Acid
2 µg/L
No EPA limit set
2/40 SYR4 2014–2019
33 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaBromoformDibromoacetic AcidHfpo-DaMonobromoacetic AcidNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
FRIEDRICHS, DAWN M.
Phone
757-433-3434
Email
[email protected]

Frequently asked questions about N a S Oceana

Is N a S Oceana tap water safe to drink?

EPA monitoring detected 11 contaminants in N a S Oceana's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in N a S Oceana's water?

EPA monitoring detected TTHM, Chloroform, Bromodichloromethane, Copper, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does N a S Oceana serve?

N a S Oceana reports serving 7,300 people in Virginia, per its EPA record.

Has N a S Oceana had any water quality violations?

The EPA has 20 violations on file for N a S Oceana, of which 18 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.