Tap WaterIndex

← Utah

Tap water quality report

Swiss Alpine Water Co

EPA monitoring tested this supplier for 61 contaminants and detected 9. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

61
contaminants tested
9
detected
300
people served
49
health-based violations
Utah rankingsLead in UtahPFAS in Utah
Water source
Ground water
Ownership
Private
Counties served
Wasatch

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

49
health-based violations
340
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2015-10-01 → 2015-10-31
MCL Health-based Resolved 2015-10-01 → 2015-10-31
MCL Health-based Resolved 2015-10-01 → 2015-10-31
MCL Health-based Resolved 2015-09-01 → 2015-09-30
MCL Health-based Resolved 2015-09-01 → 2015-09-30
MCL Health-based Resolved 2015-09-01 → 2015-09-30
MCL Health-based Resolved 2015-05-01 → 2015-05-31
MCL Health-based Resolved 2015-05-01 → 2015-05-31
MCL Health-based Resolved 2015-05-01 → 2015-05-31
MCL Health-based Resolved 2015-05-01 → 2015-05-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
168.883 µg/L 13%
of the EPA limit 1300 µg/L
worst single sample: 309 µg/L
20/22 SYR4 2013–2019
Lead
0.0056 mg/L 37%
of the EPA limit 0.0150 mg/L
 16/16 LCR 2025
Lead
6.229 µg/L 42%
of the EPA limit 15 µg/L
 16/19 SYR4 2013–2019
Nitrate
106 µg/L 1.1%
of the EPA limit 10000 µg/L
 4/6 SYR4 2012–2015
Fluoride
391 µg/L 9.8%
of the EPA limit 4000 µg/L
worst single sample: 400 µg/L
3/3 SYR4 2013–2019
Nitrate-Nitrite
306.7 µg/L 3.1%
of the EPA limit 10000 µg/L
worst single sample: 329 µg/L
3/5 SYR4 2012–2019
Barium
18.955 µg/L 0.9%
of the EPA limit 2000 µg/L
worst single sample: 19 µg/L
2/3 SYR4 2013–2019
Arsenic
0.7000 µg/L 7%
of the EPA limit 10 µg/L
 1/3 SYR4 2013–2019
Selenium
3 µg/L 6%
of the EPA limit 50 µg/L
 1/3 SYR4 2013–2019
52 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEndrinEthylbenzeneHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
TOWNSEND, KIM
Phone
801-540-2407
Email
[email protected]

Frequently asked questions about Swiss Alpine Water Co

Is Swiss Alpine Water Co tap water safe to drink?

EPA monitoring detected 9 contaminants in Swiss Alpine Water Co's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Swiss Alpine Water Co's water?

EPA monitoring detected Copper, Lead, Lead, Nitrate, Fluoride, and others. The full list with the level and data source for each is above.

How many people does Swiss Alpine Water Co serve?

Swiss Alpine Water Co reports serving 300 people in Utah, per its EPA record.

Has Swiss Alpine Water Co had any water quality violations?

The EPA has 340 violations on file for Swiss Alpine Water Co, of which 49 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.