Is Myton City Tap Water Safe? Quality Report

Water source: SWP
Ownership: Local government
Counties served: Duchesne

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

114

violations on file

still open

Violation	Type	Status	Period
Other	Monitoring	Resolved	2025-10-02
Other	Monitoring	Resolved	2025-10-02
Other	Monitoring	Resolved	2024-07-01
Other	Monitoring	Resolved	2024-07-01
Other	Monitoring	Resolved	2024-07-01
Other	Monitoring	Resolved	2020-10-02
Other	Monitoring	Resolved	2020-10-02
MON	Monitoring	Resolved	2018-05-01 → 2018-05-31
MON	Monitoring	Resolved	2018-05-01 → 2018-05-31
MON	Monitoring	Resolved	2018-05-01 → 2018-05-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Bromodichloromethane	12.33 µg/L No EPA limit set worst single sample: 13.2 µg/L	28/28	SYR4	2015–2019
Chloroform	59.84 µg/L No EPA limit set worst single sample: 61.8 µg/L	28/28	SYR4	2015–2019
Dibromochloromethane	4.1 µg/L No EPA limit set worst single sample: 4.2 µg/L	28/28	SYR4	2015–2019
Dichloroacetic Acid	17.755 µg/L No EPA limit set worst single sample: 18.8 µg/L	28/28	SYR4	2015–2019
TTHM	76.035 µg/L 95% of the EPA limit 80 µg/L worst single sample: 78.9 µg/L	28/28	SYR4	2015–2019
Total Haloacetic Acids (HAA5)	34.365 µg/L 57% of the EPA limit 60 µg/L worst single sample: 44.9 µg/L	28/28	SYR4	2015–2019
Trichloroacetic Acid	24.59 µg/L No EPA limit set worst single sample: 26.1 µg/L	28/28	SYR4	2015–2019
Copper	108.3 µg/L 8.3% of the EPA limit 1300 µg/L worst single sample: 130.7 µg/L	21/21	SYR4	2012–2018
Lead	0.0015 mg/L 10% of the EPA limit 0.0150 mg/L	21/21	LCR	2024
Lead	12.88 µg/L 86% of the EPA limit 15 µg/L worst single sample: 13.6 µg/L	7/21	SYR4	2012–2018
Dibromoacetic Acid	1.2 µg/L No EPA limit set	4/28	SYR4	2015–2019

3 contaminants tested, none detected

BromoformMonobromoacetic AcidMonochloroacetic Acid

Utility contact

Contact: ALLRED, ALAN M
Phone: 435-823-2796
Email: [email protected]

Frequently asked questions about Myton City

Is Myton City tap water safe to drink?

EPA monitoring detected 11 contaminants in Myton City's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Myton City's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dibromochloromethane, Dichloroacetic Acid, TTHM, and others. The full list with the level and data source for each is above.

How many people does Myton City serve?

Myton City reports serving 1,075 people in Utah, per its EPA record.

Has Myton City had any water quality violations?

The EPA has 114 violations on file for Myton City, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.