← Texas

Tap water quality report

Millsap Wsc

EPA monitoring tested this supplier for 14 contaminants and detected 14. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
14
detected
1,503
people served
12
health-based violations
Water source
SWP
Ownership
Local government
Counties served
Parker

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

12
health-based violations
29
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2017-04-01 → 2017-06-30
MCL Health-based Resolved 2011-05-01 → 2011-05-31
MCL Health-based Resolved 2011-05-01 → 2011-05-31
MCL Health-based Resolved 2011-05-01 → 2011-05-31
MCL Health-based Resolved 2011-05-01 → 2011-05-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31
MCL Health-based Resolved 2004-10-01 → 2004-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
17.62 µg/L
No EPA limit set
worst single sample: 20.8 µg/L
45/45 SYR4 2012–2019
Dibromochloromethane
27.12 µg/L
No EPA limit set
worst single sample: 32.9 µg/L
45/45 SYR4 2012–2019
Dichloroacetic Acid
15.5 µg/L
No EPA limit set
worst single sample: 18.3 µg/L
45/45 SYR4 2012–2019
TTHM
75.56 µg/L 94%
of the EPA limit 80 µg/L
worst single sample: 103 µg/L
45/45 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
36.92 µg/L 62%
of the EPA limit 60 µg/L
worst single sample: 38.2 µg/L
45/45 SYR4 2012–2019
Bromoform
43.03 µg/L
No EPA limit set
worst single sample: 57.7 µg/L
44/45 SYR4 2012–2019
Dibromoacetic Acid
22.19 µg/L
No EPA limit set
worst single sample: 28 µg/L
44/45 SYR4 2012–2019
Chloroform
14.93 µg/L
No EPA limit set
worst single sample: 17.1 µg/L
39/45 SYR4 2012–2019
Monobromoacetic Acid
5.625 µg/L
No EPA limit set
worst single sample: 9.9 µg/L
36/45 SYR4 2012–2019
Trichloroacetic Acid
3.955 µg/L
No EPA limit set
worst single sample: 4.5 µg/L
24/45 SYR4 2012–2019
Monochloroacetic Acid
3.48 µg/L
No EPA limit set
worst single sample: 4.2 µg/L
17/45 SYR4 2012–2019
Copper
89.2 µg/L 6.9%
of the EPA limit 1300 µg/L
worst single sample: 120 µg/L
15/20 SYR4 2015–2018
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
7/7 LCR 2025
Lead
2.28 µg/L 15%
of the EPA limit 15 µg/L
worst single sample: 2.4 µg/L
4/20 SYR4 2015–2018

Utility contact

Contact
FRENCH, JAMIE L.
Phone
940-682-4416
Email
[email protected]

Frequently asked questions about Millsap Wsc

Is Millsap Wsc tap water safe to drink?

EPA monitoring detected 14 contaminants in Millsap Wsc's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Millsap Wsc's water?

EPA monitoring detected Bromodichloromethane, Dibromochloromethane, Dichloroacetic Acid, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Millsap Wsc serve?

Millsap Wsc reports serving 1,503 people in Texas, per its EPA record.

Has Millsap Wsc had any water quality violations?

The EPA has 29 violations on file for Millsap Wsc, of which 12 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.