Tap WaterIndex

← Texas

Tap water quality report

Roman Forest Pud 3

EPA monitoring tested this supplier for 14 contaminants and detected 6. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

14
contaminants tested
6
detected
549
people served
0
health-based violations
Texas rankingsLead in TexasPFAS in Texas
Water source
GWP
Ownership
Local government
Counties served
Montgomery

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
109
violations on file
1
still open
ViolationTypeStatusPeriod
MR Monitoring Unaddressed 2025-09-29
MR Monitoring Resolved 2022-12-30
MR Monitoring Resolved 2022-12-30
Other Monitoring Resolved 2022-09-01
Other Monitoring Resolved 2022-09-01
Other Monitoring Resolved 2022-04-02
Other Monitoring Resolved 2022-04-02
Other Monitoring Resolved 2022-01-29
Other Monitoring Resolved 2022-01-29
MR Monitoring Resolved 2022-01-01 → 2022-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
161.1 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 162 µg/L
10/10 SYR4 2016–2019
Lead
0.0015 mg/L 10%
of the EPA limit 0.0150 mg/L
 7/7 LCR 2025
Bromoform
3.37 µg/L
No EPA limit set
worst single sample: 3.4 µg/L
2/2 SYR4 2016–2019
Dibromochloromethane
2.09 µg/L
No EPA limit set
worst single sample: 2.1 µg/L
2/2 SYR4 2016–2019
Lead
2.9 µg/L 19%
of the EPA limit 15 µg/L
worst single sample: 3 µg/L
2/10 SYR4 2016–2019
TTHM
5.46 µg/L 6.8%
of the EPA limit 80 µg/L
worst single sample: 5.5 µg/L
2/2 SYR4 2016–2019
8 contaminants tested, none detected
BromodichloromethaneChloroformDibromoacetic AcidDichloroacetic AcidMonobromoacetic AcidMonochloroacetic AcidTotal Haloacetic Acids (HAA5)Trichloroacetic Acid

Utility contact

Contact
RAWLINS, RUTH ANN
Email
[email protected]

Frequently asked questions about Roman Forest Pud 3

Is Roman Forest Pud 3 tap water safe to drink?

EPA monitoring detected 6 contaminants in Roman Forest Pud 3's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Roman Forest Pud 3's water?

EPA monitoring detected Copper, Lead, Bromoform, Dibromochloromethane, Lead, and others. The full list with the level and data source for each is above.

How many people does Roman Forest Pud 3 serve?

Roman Forest Pud 3 reports serving 549 people in Texas, per its EPA record.

Has Roman Forest Pud 3 had any water quality violations?

The EPA has 109 violations on file for Roman Forest Pud 3, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.