Compliance record
Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.
11
health-based violations
13
violations on file
0
still open
| Violation | Type | Status | Period |
|---|---|---|---|
| MCL | Health-based | Resolved | 2016-01-01 → 2016-03-31 |
| MCL | Health-based | Resolved | 2016-01-01 → 2016-03-31 |
| MCL | Health-based | Resolved | 2016-01-01 → 2016-03-31 |
| MCL | Health-based | Resolved | 2016-01-01 → 2016-03-31 |
| MCL | Health-based | Resolved | 2015-10-01 → 2015-12-31 |
| MCL | Health-based | Resolved | 2015-10-01 → 2015-12-31 |
| MCL | Health-based | Resolved | 2015-10-01 → 2015-12-31 |
| MCL | Health-based | Resolved | 2015-10-01 → 2015-12-31 |
| MCL | Health-based | Archived | 1982-10-29 → 1983-10-28 |
| MCL | Health-based | Archived | 1979-07-19 → 1980-07-18 |
PFAS detected
PFAS are industrial “forever chemicals”. These are the EPA's latest
nationwide test results (2023–2025).
Other contaminants detected
Each bar shows the measured level as a share of the EPA limit: green is
well under, amber is close to it, red is over. For lead and copper the
limit applies to exactly the 90th-percentile figure shown, so red there
means a real exceedance. For everything else the limit applies to a
running annual average while the figure is the 95th percentile of this
system's samples — over 100% is worth reading, but is not by itself a
violation. Where a single sample came in higher than that percentile, it
is noted under the bar. Formal violations are listed separately.
| Contaminant | Level vs EPA limit | Detection rate | Source | Period |
|---|---|---|---|---|
| Dibromochloromethane | 23.445 µg/L No EPA limit set
worst single sample: 28.1 µg/L | 134/136 | SYR4 | 2012–2019 |
| Bromodichloromethane | 24.235 µg/L No EPA limit set
worst single sample: 28.1 µg/L | 132/136 | SYR4 | 2012–2019 |
| Chloroform | 25.71 µg/L No EPA limit set
worst single sample: 59 µg/L | 127/136 | SYR4 | 2012–2019 |
| Bromoform | 8.085 µg/L No EPA limit set
worst single sample: 9.1 µg/L | 124/136 | SYR4 | 2012–2019 |
| TTHM | 79.12 µg/L 99% of the EPA limit 80 µg/L
worst single sample: 115 µg/L | 117/118 | SYR4 | 2012–2019 |
| Dichloroacetic Acid | 13.42 µg/L No EPA limit set
worst single sample: 17.6 µg/L | 113/118 | SYR4 | 2012–2019 |
| Total Haloacetic Acids (HAA5) | 30.1 µg/L 50% of the EPA limit 60 µg/L
worst single sample: 37.9 µg/L | 113/118 | SYR4 | 2012–2019 |
| Trichloroacetic Acid | 9.61 µg/L No EPA limit set
worst single sample: 12.3 µg/L | 107/118 | SYR4 | 2012–2019 |
| Dibromoacetic Acid | 6.785 µg/L No EPA limit set
worst single sample: 8.3 µg/L | 104/118 | SYR4 | 2012–2019 |
| Copper | 151.9 µg/L 12% of the EPA limit 1300 µg/L
worst single sample: 341 µg/L | 87/96 | SYR4 | 2012–2019 |
| Nitrate | 1830 µg/L 18% of the EPA limit 10000 µg/L
worst single sample: 1870 µg/L | 78/80 | SYR4 | 2012–2019 |
| Lead | 11.9 µg/L 79% of the EPA limit 15 µg/L
worst single sample: 22.7 µg/L | 41/96 | SYR4 | 2012–2019 |
| Monobromoacetic Acid | 1.5 µg/L No EPA limit set
worst single sample: 1.6 µg/L | 27/118 | SYR4 | 2012–2019 |
| Monochloroacetic Acid | 4.85 µg/L No EPA limit set
worst single sample: 5 µg/L | 16/118 | SYR4 | 2012–2019 |
| Fluoride | 2928 µg/L 73% of the EPA limit 4000 µg/L
worst single sample: 2980 µg/L | 14/14 | SYR4 | 2012–2019 |
| Lead | 0.0019 mg/L 13% of the EPA limit 0.0150 mg/L | 14/14 | LCR | 2025 |
| Xylenes, Total | 19.75 µg/L 0.2% of the EPA limit 10000 µg/L
worst single sample: 23 µg/L | 14/18 | SYR4 | 2012–2019 |
| Nitrate-Nitrite | 1322 µg/L 13% of the EPA limit 10000 µg/L
worst single sample: 1640 µg/L | 13/13 | SYR4 | 2012–2019 |
| Barium | 191.6 µg/L 9.6% of the EPA limit 2000 µg/L
worst single sample: 196 µg/L | 9/9 | SYR4 | 2013–2019 |
| Ethylbenzene | 4 µg/L 0.6% of the EPA limit 700 µg/L
worst single sample: 4.3 µg/L | 7/18 | SYR4 | 2012–2019 |
| Combined Radium (-226 And -228) | 1.5305 pCi/L 31% of the EPA limit 5 pCi/L
worst single sample: 1.55 pCi/L | 4/4 | SYR4 | 2013–2019 |
| Gross Alpha, Excl. Radon And U | 10.78 pCi/L 72% of the EPA limit 15 pCi/L
worst single sample: 11.1 pCi/L | 3/3 | SYR4 | 2017–2019 |
| Lithium | 12.6 µg/L No EPA limit set | 2/10 | UCMR-5 | 2024 |
| Arsenic | 1.11 µg/L 11% of the EPA limit 10 µg/L | 1/9 | SYR4 | 2013–2019 |
| Chromium | 2.13 µg/L 2.1% of the EPA limit 100 µg/L | 1/9 | SYR4 | 2013–2019 |
| Selenium | 1.16 µg/L 2.3% of the EPA limit 50 µg/L | 1/9 | SYR4 | 2013–2019 |
| Thallium, Total | 0.3510 µg/L 18% of the EPA limit 2 µg/L | 1/9 | SYR4 | 2013–2019 |
79 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebEthylene DibromideEndrinGross Beta Particle ActivityHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNetfosaaNfdhaNmefosaaNitriteOxamylPFBSPfdaPfdoaPfeesaPfhpaPfhpsPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpesPftaPftrdaPfunaPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneTolueneToxapheneTrichloroethyleneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene
Utility contact
Frequently asked questions about City of Kyle
Is City of Kyle tap water safe to drink?
EPA monitoring detected 30 contaminants in City of Kyle's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.
What contaminants were detected in City of Kyle's water?
EPA monitoring detected Dibromochloromethane, Bromodichloromethane, Chloroform, Bromoform, TTHM, and others. The full list with the level and data source for each is above.
How many people does City of Kyle serve?
City of Kyle reports serving 52,000 people in Texas, per its EPA record.
Has City of Kyle had any water quality violations?
The EPA has 13 violations on file for City of Kyle, of which 11 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.
Where does this data come from?
Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.