← Tennessee

Tap water quality report

Selmer Water

EPA monitoring tested this supplier for 60 contaminants and detected 4. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

60
contaminants tested
4
detected
20,648
people served
4
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
McNairy

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
30
violations on file
3
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2009-10-01 → 2009-10-31
MCL Health-based Resolved 2009-10-01 → 2009-10-31
MCL Health-based Resolved 2009-10-01 → 2009-10-31
MCL Health-based Resolved 2009-10-01 → 2009-10-31
Other Monitoring Unaddressed 2024-07-01
Other Monitoring Unaddressed 2022-07-01
Other Monitoring Unaddressed 2022-07-01
MR Monitoring Resolved 2018-10-01
MR Monitoring Resolved 2018-10-01
MR Monitoring Resolved 2018-10-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
7.1275 µg/L 8.9%
of the EPA limit 80 µg/L
worst single sample: 10 µg/L
22/30 SYR4 2014–2019
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
14/14 LCR 2025
Lithium
72.9 µg/L
No EPA limit set
6/6 UCMR-5 2024
Total Haloacetic Acids (HAA5)
3.38 µg/L 5.6%
of the EPA limit 60 µg/L
worst single sample: 3.86 µg/L
5/30 SYR4 2014–2019
56 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAtrazineBenzeneChlorobenzeneCarbon TetrachlorideDichloromethaneEthylbenzeneGross Alpha, Excl. Radon And UHfpo-DaLassoNetfosaaNfdhaNmefosaaNitratePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaPicloramStyreneTetrachloroethyleneTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
COLEMAN, JUSTIN
Phone
731-645-7928
Email
[email protected]

Frequently asked questions about Selmer Water

Is Selmer Water tap water safe to drink?

EPA monitoring detected 4 contaminants in Selmer Water's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Selmer Water's water?

EPA monitoring detected TTHM, Lead, Lithium, Total Haloacetic Acids (HAA5). The full list with the level and data source for each is above.

How many people does Selmer Water serve?

Selmer Water reports serving 20,648 people in Tennessee, per its EPA record.

Has Selmer Water had any water quality violations?

The EPA has 30 violations on file for Selmer Water, of which 4 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.