Tap WaterIndex

← Tennessee

Tap water quality report

Hillsville Utility District

EPA monitoring tested this supplier for 33 contaminants and detected 10. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

33
contaminants tested
10
detected
11,325
people served
3
health-based violations
Tennessee rankingsLead in TennesseePFAS in Tennessee
Water source
SWP
Ownership
Local government
Counties served
Coffee

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
16
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2009-09-01 → 2009-09-30
MCL Health-based Resolved 2009-09-01 → 2009-09-30
MCL Health-based Resolved 2009-09-01 → 2009-09-30
Other Monitoring Resolved 2021-07-01
Other Monitoring Resolved 2021-07-01
MR Monitoring Resolved 2012-06-01 → 2012-06-30
MR Monitoring Resolved 2012-06-01 → 2012-06-30
MR Monitoring Resolved 2012-06-01 → 2012-06-30
MR Monitoring Resolved 2012-06-01 → 2012-06-30
MR Monitoring Resolved 2012-04-01 → 2012-06-30

PFAS detected

PFAS are industrial “forever chemicals”. These are the EPA's latest nationwide test results (2023–2025).
ContaminantMaxDetection ratePeriod
PFBS 0.0099 µg/L 4/4 2023
Pfhxa 0.0073 µg/L 4/4 2023
PFOA 0.0119 µg/L 4/4 2023
PFOS 0.0073 µg/L 4/4 2023
Pfpea 0.0059 µg/L 4/4 2023
Pfhpa 0.0039 µg/L 3/4 2023
Pfba 0.0062 µg/L 2/4 2023

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
TTHM
53.325 µg/L 67%
of the EPA limit 80 µg/L
worst single sample: 62.7 µg/L
50/50 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
60.1 µg/L 100%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 66.4 µg/L
50/50 SYR4 2014–2019
Lead
0.00080 mg/L 5.3%
of the EPA limit 0.0150 mg/L
 12/12 LCR 2025
23 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfdaPfdoaPfeesaPfhpsPFHXSPfmbaPfmpaPFNAPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
GALLAGHER, DUSTIN
Phone
931-728-1242
Email
[email protected]

Frequently asked questions about Hillsville Utility District

Is Hillsville Utility District tap water safe to drink?

EPA monitoring detected 10 contaminants in Hillsville Utility District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hillsville Utility District's water?

EPA monitoring detected TTHM, Total Haloacetic Acids (HAA5), Lead, PFBS, Pfhxa, and others. The full list with the level and data source for each is above.

How many people does Hillsville Utility District serve?

Hillsville Utility District reports serving 11,325 people in Tennessee, per its EPA record.

Has Hillsville Utility District had any water quality violations?

The EPA has 16 violations on file for Hillsville Utility District, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.