Tap WaterIndex

← South Dakota

Tap water quality report

Platte

EPA monitoring tested this supplier for 5 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

5
contaminants tested
5
detected
1,256
people served
10
health-based violations
South Dakota rankingsLead in South DakotaPFAS in South Dakota
Water source
SWP
Ownership
Local government
Counties served
Charles Mix

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

10
health-based violations
23
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2017-02-01
TT Health-based Resolved 2017-02-01
TT Health-based Resolved 2010-10-17 → 2011-06-30
TT Health-based Resolved 2010-10-17 → 2011-06-30
TT Health-based Resolved 2010-04-10 → 2010-04-23
TT Health-based Resolved 2010-04-10 → 2010-04-23
TT Health-based Resolved 2009-10-22 → 2010-04-23
TT Health-based Resolved 2009-10-22 → 2010-04-23
TT Health-based Resolved 2009-04-25 → 2010-04-23
TT Health-based Resolved 2009-04-25 → 2010-04-23

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
110.5 µg/L 8.5%
of the EPA limit 1300 µg/L
worst single sample: 130 µg/L
40/40 SYR4 2012–2018
Lead
13.925 µg/L 93%
of the EPA limit 15 µg/L
worst single sample: 18.3 µg/L
40/40 SYR4 2012–2018
TTHM
79.1025 µg/L 99%
of the EPA limit 80 µg/L
worst single sample: 109 µg/L
22/22 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
63.7175 µg/L 106%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 68.3 µg/L
22/22 SYR4 2013–2019
Lead
0.0140 mg/L 93%
of the EPA limit 0.0150 mg/L
 18/18 LCR 2024

Utility contact

Contact
RICHARD STERNBERG
Phone
6053373921
Email
[email protected]

Frequently asked questions about Platte

Is Platte tap water safe to drink?

EPA monitoring detected 5 contaminants in Platte's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Platte's water?

EPA monitoring detected Copper, Lead, TTHM, Total Haloacetic Acids (HAA5), Lead. The full list with the level and data source for each is above.

How many people does Platte serve?

Platte reports serving 1,256 people in South Dakota, per its EPA record.

Has Platte had any water quality violations?

The EPA has 23 violations on file for Platte, of which 10 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.