Tap WaterIndex

← South Carolina

Tap water quality report

Bel Air Mhp (sc4060009)

EPA monitoring tested this supplier for 66 contaminants and detected 5. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

66
contaminants tested
5
detected
34
people served
8
health-based violations
South Carolina rankingsLead in South CarolinaPFAS in South Carolina
Water source
Ground water
Ownership
Private
Counties served
Richland

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

8
health-based violations
75
violations on file
7
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
TT Health-based Resolved 2024-10-17
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MCL Health-based Resolved 2010-08-01 → 2010-08-31
MR Monitoring Unaddressed 2026-01-01
MR Monitoring Unaddressed 2026-01-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
225.5 µg/L 2.3%
of the EPA limit 10000 µg/L
worst single sample: 230 µg/L
30/32 SYR4 2012–2019
Lead
0.0 mg/L 0%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2022
Copper
64.4 µg/L 5%
of the EPA limit 1300 µg/L
worst single sample: 95 µg/L
10/16 SYR4 2014–2019
Lead
3.8 µg/L 25%
of the EPA limit 15 µg/L
worst single sample: 4 µg/L
3/16 SYR4 2014–2019
Nitrate-Nitrite
190 µg/L 1.9%
of the EPA limit 10000 µg/L
 2/2 SYR4 2017
61 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBariumBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined Radium (-226 And -228)DichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndrinEthylbenzeneFluorideGlyphosateGross Alpha, Excl. Radon And UHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
LONG, STEVE
Phone
803-795-2646
Email
[email protected]; [email protected]

Frequently asked questions about Bel Air Mhp (sc4060009)

Is Bel Air Mhp (sc4060009) tap water safe to drink?

EPA monitoring detected 5 contaminants in Bel Air Mhp (sc4060009)'s water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bel Air Mhp (sc4060009)'s water?

EPA monitoring detected Nitrate, Lead, Copper, Lead, Nitrate-Nitrite. The full list with the level and data source for each is above.

How many people does Bel Air Mhp (sc4060009) serve?

Bel Air Mhp (sc4060009) reports serving 34 people in South Carolina, per its EPA record.

Has Bel Air Mhp (sc4060009) had any water quality violations?

The EPA has 75 violations on file for Bel Air Mhp (sc4060009), of which 8 are health-based (a contaminant limit or required treatment was breached) and 7 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.