Tap WaterIndex

← South Carolina

Tap water quality report

Blue Ridge Water Co Inc (sc2320003)

EPA monitoring tested this supplier for 44 contaminants and detected 12. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

44
contaminants tested
12
detected
40,006
people served
0
health-based violations
South Carolina rankingsLead in South CarolinaPFAS in South Carolina
Water source
SWP
Ownership
Local government
Counties served
Greenville

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
1
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2009-01-02

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
7.5955 µg/L
No EPA limit set
worst single sample: 9.76 µg/L
128/128 SYR4 2012–2019
Chloroform
37.025 µg/L
No EPA limit set
worst single sample: 42.4 µg/L
128/128 SYR4 2012–2019
Dichloroacetic Acid
23.295 µg/L
No EPA limit set
worst single sample: 32.51 µg/L
128/128 SYR4 2012–2019
TTHM
43.69 µg/L 55%
of the EPA limit 80 µg/L
worst single sample: 50.8 µg/L
128/128 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
36.655 µg/L 61%
of the EPA limit 60 µg/L
worst single sample: 47.55 µg/L
128/128 SYR4 2012–2019
Trichloroacetic Acid
13.74 µg/L
No EPA limit set
worst single sample: 15.3 µg/L
127/128 SYR4 2012–2019
Copper
223 µg/L 17%
of the EPA limit 1300 µg/L
worst single sample: 383 µg/L
86/90 SYR4 2012–2018
Dibromochloromethane
1.5 µg/L
No EPA limit set
worst single sample: 1.6 µg/L
47/128 SYR4 2012–2019
Lead
0.0070 mg/L 47%
of the EPA limit 0.0150 mg/L
 22/22 LCR 2024
Lead
8.8 µg/L 59%
of the EPA limit 15 µg/L
worst single sample: 11 µg/L
12/90 SYR4 2012–2018
Monobromoacetic Acid
3.155 µg/L
No EPA limit set
worst single sample: 3.29 µg/L
11/128 SYR4 2012–2019
Dibromoacetic Acid
1.085 µg/L
No EPA limit set
worst single sample: 1.1 µg/L
4/128 SYR4 2012–2019
32 contaminants tested, none detected
11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaBromoformHfpo-DaMonochloroacetic AcidNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact
POWERS, BRAD
Phone
864-895-1719
Email
[email protected]

Frequently asked questions about Blue Ridge Water Co Inc (sc2320003)

Is Blue Ridge Water Co Inc (sc2320003) tap water safe to drink?

EPA monitoring detected 12 contaminants in Blue Ridge Water Co Inc (sc2320003)'s water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Blue Ridge Water Co Inc (sc2320003)'s water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dichloroacetic Acid, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Blue Ridge Water Co Inc (sc2320003) serve?

Blue Ridge Water Co Inc (sc2320003) reports serving 40,006 people in South Carolina, per its EPA record.

Has Blue Ridge Water Co Inc (sc2320003) had any water quality violations?

The EPA has 1 violation on file for Blue Ridge Water Co Inc (sc2320003), of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.