← Massachusetts

Tap water quality report

Nasonville Water District

EPA monitoring tested this supplier for 52 contaminants and detected 17. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

52
contaminants tested
17
detected
150
people served
0
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Providence

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
186
violations on file
0
still open
ViolationTypeStatusPeriod
MR Monitoring Resolved 2024-12-30
MR Monitoring Resolved 2024-12-30
MR Monitoring Resolved 2024-12-30
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31
MR Monitoring Resolved 2024-01-01 → 2024-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
1307 µg/L 13%
of the EPA limit 10000 µg/L
worst single sample: 1310 µg/L
22/22 SYR4 2012–2019
Lead
0.0010 mg/L 6.7%
of the EPA limit 0.0150 mg/L
13/13 LCR 2024
Nitrate-Nitrite
320 µg/L 3.2%
of the EPA limit 10000 µg/L
8/8 SYR4 2014–2018
Barium
14 µg/L 0.7%
of the EPA limit 2000 µg/L
worst single sample: 15 µg/L
6/6 SYR4 2013–2019
Bromodichloromethane
1.998 µg/L
No EPA limit set
worst single sample: 2.09 µg/L
5/5 SYR4 2013–2018
Copper
340 µg/L 26%
of the EPA limit 1300 µg/L
worst single sample: 350 µg/L
5/5 SYR4 2018
Dibromochloromethane
2.316 µg/L
No EPA limit set
worst single sample: 2.38 µg/L
5/5 SYR4 2013–2018
Dibromoacetic Acid
1.3265 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
4/5 SYR4 2013–2018
TTHM
5.7335 µg/L 7.2%
of the EPA limit 80 µg/L
worst single sample: 5.75 µg/L
4/5 SYR4 2013–2018
Bromoform
1.121 µg/L
No EPA limit set
worst single sample: 1.17 µg/L
3/5 SYR4 2013–2018
Chloroform
1.398 µg/L
No EPA limit set
worst single sample: 1.49 µg/L
3/5 SYR4 2013–2018
Chromium
1 µg/L 1%
of the EPA limit 100 µg/L
3/6 SYR4 2013–2019
Lead
2 µg/L 13%
of the EPA limit 15 µg/L
3/5 SYR4 2018
Monochloroacetic Acid
1.8415 µg/L
No EPA limit set
worst single sample: 1.9 µg/L
2/5 SYR4 2013–2018
Total Haloacetic Acids (HAA5)
2.48 µg/L 4.1%
of the EPA limit 60 µg/L
worst single sample: 2.5 µg/L
2/5 SYR4 2013–2018
Dichloroacetic Acid
1 µg/L
No EPA limit set
1/5 SYR4 2013–2018
Monobromoacetic Acid
0.4600 µg/L
No EPA limit set
1/5 SYR4 2013–2018
35 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideCombined Radium (-226 And -228)Combined UraniumDichloromethaneEthylbenzeneFluorideGross Alpha, Excl. Radon And UMercuryNitriteSeleniumStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
CHENEY, STEVEN
Phone
508-234-7358
Email
[email protected]

Frequently asked questions about Nasonville Water District

Is Nasonville Water District tap water safe to drink?

EPA monitoring detected 17 contaminants in Nasonville Water District's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Nasonville Water District's water?

EPA monitoring detected Nitrate, Lead, Nitrate-Nitrite, Barium, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does Nasonville Water District serve?

Nasonville Water District reports serving 150 people in Massachusetts, per its EPA record.

Has Nasonville Water District had any water quality violations?

The EPA has 186 violations on file for Nasonville Water District, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.