← Pennsylvania

Tap water quality report

Hanover Muni Water Works

EPA monitoring tested this supplier for 110 contaminants and detected 18. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

110
contaminants tested
18
detected
40,900
people served
15
health-based violations
Water source
Surface water
Ownership
Local government
Counties served
York

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

15
health-based violations
250
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2018-10-01 → 2018-12-31
TT Health-based Resolved 2018-10-01 → 2018-12-31
TT Health-based Resolved 2018-06-01 → 2018-06-30
TT Health-based Resolved 2018-06-01 → 2018-06-30
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2014-10-01 → 2014-12-31
MCL Health-based Resolved 2004-06-01 → 2004-06-30
MCL Health-based Resolved 2004-06-01 → 2004-06-30
MCL Health-based Resolved 2004-06-01 → 2004-06-30

PFAS detected

PFAS are industrial “forever chemicals”. These are the EPA's latest nationwide test results (2023–2025).
ContaminantMaxDetection ratePeriod
Pfpea 0.0046 µg/L 2/4 2023

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Total Haloacetic Acids (HAA5)
58.37 µg/L 97%
of the EPA limit 60 µg/L
worst single sample: 74 µg/L
142/142 SYR4 2012–2019
Bromodichloromethane
13.82 µg/L
No EPA limit set
worst single sample: 17.7 µg/L
137/137 SYR4 2012–2019
Chloroform
76.38 µg/L
No EPA limit set
worst single sample: 136 µg/L
137/137 SYR4 2012–2019
TTHM
96.98 µg/L 121%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 152 µg/L
134/134 SYR4 2012–2019
Dibromochloromethane
2.83 µg/L
No EPA limit set
worst single sample: 3.7 µg/L
128/134 SYR4 2012–2019
Copper
569 µg/L 44%
of the EPA limit 1300 µg/L
worst single sample: 930 µg/L
72/91 SYR4 2013–2019
Dichloroacetic Acid
25 µg/L
No EPA limit set
worst single sample: 32 µg/L
48/48 SYR4 2017–2019
Trichloroacetic Acid
12.65 µg/L
No EPA limit set
worst single sample: 15 µg/L
48/48 SYR4 2017–2019
Lead
16.4 µg/L 109%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 38 µg/L
17/91 SYR4 2013–2019
Nitrate
2870 µg/L 29%
of the EPA limit 10000 µg/L
16/16 SYR4 2012–2019
Lead
0.0020 mg/L 13%
of the EPA limit 0.0150 mg/L
15/15 LCR 2025
Fluoride
829.5 µg/L 21%
of the EPA limit 4000 µg/L
worst single sample: 840 µg/L
8/8 SYR4 2012–2019
Barium
19 µg/L 1%
of the EPA limit 2000 µg/L
5/9 SYR4 2012–2019
Atrazine
0.3100 µg/L 10%
of the EPA limit 3 µg/L
3/12 SYR4 2012–2019
Bromoform
0.9835 µg/L
No EPA limit set
worst single sample: 1 µg/L
2/132 SYR4 2012–2019
Dibromoacetic Acid
1 µg/L
No EPA limit set
2/48 SYR4 2017–2019
Monochloroacetic Acid
2 µg/L
No EPA limit set
1/48 SYR4 2017–2019
92 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS2,3,7,8-TCDD2,4,5-TP2,4-D4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAsbestosBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHfpo-DaHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidNetfosaaNfdhaNmefosaaNitriteOxamylPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpesPftaPftrdaPfunaPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneLithiumO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
KEVAN Anschuetz
Phone
717-632-5152

Frequently asked questions about Hanover Muni Water Works

Is Hanover Muni Water Works tap water safe to drink?

EPA monitoring detected 18 contaminants in Hanover Muni Water Works's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Hanover Muni Water Works's water?

EPA monitoring detected Total Haloacetic Acids (HAA5), Bromodichloromethane, Chloroform, TTHM, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Hanover Muni Water Works serve?

Hanover Muni Water Works reports serving 40,900 people in Pennsylvania, per its EPA record.

Has Hanover Muni Water Works had any water quality violations?

The EPA has 250 violations on file for Hanover Muni Water Works, of which 15 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.