Tap WaterIndex

← Pennsylvania

Tap water quality report

Orchard Hills Mhp

EPA monitoring tested this supplier for 80 contaminants and detected 11. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
11
detected
303
people served
33
health-based violations
Pennsylvania rankingsLead in PennsylvaniaPFAS in Pennsylvania
Water source
Ground water
Ownership
Private
Counties served
Perry

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

33
health-based violations
82
violations on file
1
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2014-11-01 → 2014-11-30
TT Health-based Resolved 2014-11-01 → 2014-11-30
TT Health-based Resolved 2011-10-01 → 2011-10-31
TT Health-based Resolved 2011-10-01 → 2011-10-31
TT Health-based Resolved 2011-10-01 → 2011-10-31
MCL Health-based Resolved 2011-08-01 → 2011-08-31
MCL Health-based Resolved 2011-08-01 → 2011-08-31
MCL Health-based Resolved 2011-08-01 → 2011-08-31
TT Health-based Resolved 2011-06-01 → 2011-06-30
TT Health-based Resolved 2011-06-01 → 2011-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Arsenic
47.7 µg/L 477%
of the EPA limit, at the 95th percentile of samples — 10 µg/L
worst single sample: 54 µg/L
39/41 SYR4 2012–2019
Copper
200 µg/L 15%
of the EPA limit 1300 µg/L
worst single sample: 303 µg/L
11/16 SYR4 2013–2019
Lead
153.4 µg/L 1023%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 154 µg/L
7/17 SYR4 2013–2019
Lead
0.1526 mg/L 1017%
above the EPA limit of 0.0150 mg/L
 4/4 LCR 2019
Barium
248.1 µg/L 12%
of the EPA limit 2000 µg/L
worst single sample: 250 µg/L
3/3 SYR4 2012–2018
Bromodichloromethane
1.385 µg/L
No EPA limit set
worst single sample: 1.4 µg/L
2/4 SYR4 2013–2018
Dibromochloromethane
1.29 µg/L
No EPA limit set
worst single sample: 1.3 µg/L
2/4 SYR4 2013–2018
Nitrate
390 µg/L 3.9%
of the EPA limit 10000 µg/L
 2/18 SYR4 2012–2019
TTHM
3.265 µg/L 4.1%
of the EPA limit 80 µg/L
worst single sample: 3.3 µg/L
2/4 SYR4 2013–2018
Bromoform
1.2 µg/L
No EPA limit set
 1/4 SYR4 2013–2018
Chromium
1 µg/L 1%
of the EPA limit 100 µg/L
 1/3 SYR4 2012–2018
69 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChloroformCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneFluorideGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Haloacetic Acids (HAA5)Total Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
FRANK T PERANO
Phone
610-286-0490

Frequently asked questions about Orchard Hills Mhp

Is Orchard Hills Mhp tap water safe to drink?

EPA monitoring detected 11 contaminants in Orchard Hills Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Orchard Hills Mhp's water?

EPA monitoring detected Arsenic, Copper, Lead, Lead, Barium, and others. The full list with the level and data source for each is above.

How many people does Orchard Hills Mhp serve?

Orchard Hills Mhp reports serving 303 people in Pennsylvania, per its EPA record.

Has Orchard Hills Mhp had any water quality violations?

The EPA has 82 violations on file for Orchard Hills Mhp, of which 33 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.