Tap WaterIndex

← Pennsylvania

Tap water quality report

State Line Mhp

EPA monitoring tested this supplier for 80 contaminants and detected 13. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
13
detected
65
people served
6
health-based violations
Pennsylvania rankingsLead in PennsylvaniaPFAS in Pennsylvania
Water source
Ground water
Ownership
Private
Counties served
Franklin

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

6
health-based violations
303
violations on file
1
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MCL Health-based Resolved 1991-05-23 → 1991-06-22
MR Monitoring Archived 2026-01-01 → 2026-01-31
MR Monitoring Archived 2026-01-01 → 2026-01-31
MR Monitoring Resolved 2026-01-01 → 2026-01-31
MR Monitoring Resolved 2026-01-01 → 2026-01-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
5130 µg/L 51%
of the EPA limit 10000 µg/L
worst single sample: 5510 µg/L
52/52 SYR4 2012–2019
Copper
153.3 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 182 µg/L
15/15 SYR4 2013–2019
Lead
12 µg/L 80%
of the EPA limit 15 µg/L
worst single sample: 13 µg/L
5/15 SYR4 2013–2019
Lead
0.0159 mg/L 106%
above the EPA limit of 0.0150 mg/L
 4/4 LCR 2025
Bromodichloromethane
0.7307 µg/L
No EPA limit set
worst single sample: 0.7350 µg/L
3/5 SYR4 2013–2019
TTHM
1.989 µg/L 2.5%
of the EPA limit 80 µg/L
worst single sample: 2.01 µg/L
3/4 SYR4 2013–2019
Chloroform
0.5993 µg/L
No EPA limit set
worst single sample: 0.6000 µg/L
2/5 SYR4 2013–2019
Dibromochloromethane
0.9800 µg/L
No EPA limit set
worst single sample: 1 µg/L
2/3 SYR4 2013–2019
Dichloroacetic Acid
6.836 µg/L
No EPA limit set
worst single sample: 7 µg/L
2/3 SYR4 2014–2019
Total Haloacetic Acids (HAA5)
6.836 µg/L 11%
of the EPA limit 60 µg/L
worst single sample: 7 µg/L
2/4 SYR4 2013–2019
Barium
37 µg/L 1.9%
of the EPA limit 2000 µg/L
 1/3 SYR4 2013–2018
Chromium
3.2 µg/L 3.2%
of the EPA limit 100 µg/L
 1/3 SYR4 2013–2018
Fluoride
160 µg/L 4%
of the EPA limit 4000 µg/L
 1/3 SYR4 2013–2018
67 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Keith Sheeley
Phone
717-860-9817

Frequently asked questions about State Line Mhp

Is State Line Mhp tap water safe to drink?

EPA monitoring detected 13 contaminants in State Line Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in State Line Mhp's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Bromodichloromethane, and others. The full list with the level and data source for each is above.

How many people does State Line Mhp serve?

State Line Mhp reports serving 65 people in Pennsylvania, per its EPA record.

Has State Line Mhp had any water quality violations?

The EPA has 303 violations on file for State Line Mhp, of which 6 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.