← Pennsylvania

Tap water quality report

Bonneauville Muni Water Auth

EPA monitoring tested this supplier for 78 contaminants and detected 19. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

78
contaminants tested
19
detected
2,730
people served
135
health-based violations
Water source
Ground water
Ownership
Local government
Counties served
Adams

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

135
health-based violations
983
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-07-01 → 2009-09-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-04-01 → 2009-06-30
MCL Health-based Resolved 2009-01-01 → 2009-03-31
MCL Health-based Resolved 2009-01-01 → 2009-03-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Nitrate
4140 µg/L 41%
of the EPA limit 10000 µg/L
worst single sample: 4300 µg/L
96/98 SYR4 2012–2019
Dibromochloromethane
5.58 µg/L
No EPA limit set
worst single sample: 6.2 µg/L
22/22 SYR4 2013–2019
Bromodichloromethane
6.08 µg/L
No EPA limit set
worst single sample: 9.5 µg/L
19/19 SYR4 2013–2019
Copper
370 µg/L 28%
of the EPA limit 1300 µg/L
worst single sample: 460 µg/L
19/30 SYR4 2013–2019
Chloroform
43.18 µg/L
No EPA limit set
worst single sample: 48.7 µg/L
17/17 SYR4 2013–2019
Bromoform
1.82 µg/L
No EPA limit set
worst single sample: 2 µg/L
13/13 SYR4 2013–2019
TTHM
54.2 µg/L 68%
of the EPA limit 80 µg/L
worst single sample: 56.9 µg/L
13/13 SYR4 2013–2019
Lead
28 µg/L 187%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 49 µg/L
11/30 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
13.15 µg/L 22%
of the EPA limit 60 µg/L
worst single sample: 14.3 µg/L
11/12 SYR4 2013–2019
Combined Uranium
9.11224 µg/L 30%
of the EPA limit 30 µg/L
worst single sample: 9.96214 µg/L
9/87 SYR4 2012–2019
Trichloroethylene
1 µg/L 20%
of the EPA limit 5 µg/L
7/24 SYR4 2012–2019
Fluoride
348 µg/L 8.7%
of the EPA limit 4000 µg/L
worst single sample: 350 µg/L
5/9 SYR4 2012–2018
Dibromoacetic Acid
1.9 µg/L
No EPA limit set
worst single sample: 2 µg/L
3/4 SYR4 2016–2019
Dichloroacetic Acid
8.7 µg/L
No EPA limit set
worst single sample: 9 µg/L
2/4 SYR4 2016–2019
Lead
0.0272 mg/L 181%
above the EPA limit of 0.0150 mg/L
2/2 LCR 1995
Trichloroacetic Acid
3.85 µg/L
No EPA limit set
worst single sample: 4 µg/L
2/4 SYR4 2016–2019
Barium
500 µg/L 25%
of the EPA limit 2000 µg/L
1/9 SYR4 2012–2018
Ethylbenzene
1.2 µg/L 0.2%
of the EPA limit 700 µg/L
1/24 SYR4 2012–2019
Xylenes, Total
5.2 µg/L 0.1%
of the EPA limit 10000 µg/L
1/24 SYR4 2012–2019
59 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,4,5-TP2,4-DAntimony, TotalArsenicAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneVinyl Chloridecis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
WESLEY CHRISMER
Phone
717-334-2616

Frequently asked questions about Bonneauville Muni Water Auth

Is Bonneauville Muni Water Auth tap water safe to drink?

EPA monitoring detected 19 contaminants in Bonneauville Muni Water Auth's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Bonneauville Muni Water Auth's water?

EPA monitoring detected Nitrate, Dibromochloromethane, Bromodichloromethane, Copper, Chloroform, and others. The full list with the level and data source for each is above.

How many people does Bonneauville Muni Water Auth serve?

Bonneauville Muni Water Auth reports serving 2,730 people in Pennsylvania, per its EPA record.

Has Bonneauville Muni Water Auth had any water quality violations?

The EPA has 983 violations on file for Bonneauville Muni Water Auth, of which 135 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.