Tap WaterIndex

← Pennsylvania

Tap water quality report

Clymer Boro Muni Auth

EPA monitoring tested this supplier for 79 contaminants and detected 17. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

79
contaminants tested
17
detected
1,700
people served
3
health-based violations
Pennsylvania rankingsLead in PennsylvaniaPFAS in Pennsylvania
Water source
Ground water
Ownership
Local government
Counties served
Indiana

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

3
health-based violations
178
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2004-01-01
TT Health-based Resolved 2004-01-01
TT Health-based Resolved 2004-01-01
MR Monitoring Resolved 2025-04-01 → 2025-04-30
MR Monitoring Resolved 2025-04-01 → 2025-04-30
MR Monitoring Resolved 2025-04-01 → 2025-04-30
MR Monitoring Resolved 2025-02-01 → 2025-02-28
MR Monitoring Resolved 2025-02-01 → 2025-02-28
MR Monitoring Resolved 2025-02-01 → 2025-02-28
MR Monitoring Resolved 2025-02-01 → 2025-02-28

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
150 µg/L 12%
of the EPA limit 1300 µg/L
worst single sample: 210 µg/L
51/60 SYR4 2016–2019
Lead
6.6 µg/L 44%
of the EPA limit 15 µg/L
worst single sample: 7.56 µg/L
25/60 SYR4 2016–2019
Bromodichloromethane
3.17 µg/L
No EPA limit set
worst single sample: 3.3 µg/L
14/14 SYR4 2012–2019
Bromoform
48.025 µg/L
No EPA limit set
worst single sample: 49 µg/L
14/14 SYR4 2012–2019
Dibromochloromethane
12.385 µg/L
No EPA limit set
worst single sample: 13.1 µg/L
14/14 SYR4 2012–2019
TTHM
58.49 µg/L 73%
of the EPA limit 80 µg/L
worst single sample: 59.4 µg/L
14/14 SYR4 2012–2019
Nitrate
200 µg/L 2%
of the EPA limit 10000 µg/L
 10/16 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
46.87 µg/L 78%
of the EPA limit 60 µg/L
worst single sample: 55 µg/L
7/10 SYR4 2012–2019
Lead
0.5090 mg/L 3393%
above the EPA limit of 0.0150 mg/L
 5/5 LCR 2002
Barium
591 µg/L 30%
of the EPA limit 2000 µg/L
worst single sample: 600 µg/L
3/3 SYR4 2012–2018
Dibromoacetic Acid
6.955 µg/L
No EPA limit set
worst single sample: 7 µg/L
3/3 SYR4 2012–2019
Fluoride
424 µg/L 11%
of the EPA limit 4000 µg/L
worst single sample: 430 µg/L
3/3 SYR4 2012–2018
Chloroform
0.8878 µg/L
No EPA limit set
worst single sample: 0.9000 µg/L
2/14 SYR4 2012–2019
Monochloroacetic Acid
3.636 µg/L
No EPA limit set
worst single sample: 3.72 µg/L
2/3 SYR4 2012–2019
Cyanide
7 µg/L 3.5%
of the EPA limit 200 µg/L
 1/3 SYR4 2012–2018
Mercury
0.2000 µg/L 10%
of the EPA limit 2 µg/L
 1/3 SYR4 2012–2018
Monobromoacetic Acid
9.42 µg/L
No EPA limit set
 1/3 SYR4 2012–2019
62 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAntimony, TotalArsenicAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMethoxychlorNitriteOxamylPentachlorophenolPicloramSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
Sonya Schrenkel
Phone
724-254-9884

Frequently asked questions about Clymer Boro Muni Auth

Is Clymer Boro Muni Auth tap water safe to drink?

EPA monitoring detected 17 contaminants in Clymer Boro Muni Auth's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Clymer Boro Muni Auth's water?

EPA monitoring detected Copper, Lead, Bromodichloromethane, Bromoform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Clymer Boro Muni Auth serve?

Clymer Boro Muni Auth reports serving 1,700 people in Pennsylvania, per its EPA record.

Has Clymer Boro Muni Auth had any water quality violations?

The EPA has 178 violations on file for Clymer Boro Muni Auth, of which 3 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.