Tap WaterIndex

← California

Tap water quality report

Brady Hills Ml

EPA monitoring tested this supplier for 80 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

80
contaminants tested
16
detected
400
people served
4
health-based violations
California rankingsLead in CaliforniaPFAS in California
Water source
Ground water
Ownership
Private
Counties served
Butler

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

4
health-based violations
275
violations on file
0
still open
ViolationTypeStatusPeriod
TT Health-based Resolved 2015-02-01 → 2015-02-28
TT Health-based Resolved 2015-02-01 → 2015-02-28
TT Health-based Resolved 2015-02-01 → 2015-02-28
TT Health-based Resolved 2015-02-01 → 2015-02-28
Other Monitoring Resolved 2025-10-01
Other Monitoring Resolved 2025-10-01
Other Monitoring Resolved 2023-01-11
Other Monitoring Resolved 2023-01-11
Other Monitoring Resolved 2023-01-11
Other Monitoring Resolved 2023-01-11

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
200.5 µg/L 15%
of the EPA limit 1300 µg/L
worst single sample: 677 µg/L
26/26 SYR4 2013–2019
Lead
9.1 µg/L 61%
of the EPA limit 15 µg/L
worst single sample: 10 µg/L
7/21 SYR4 2013–2019
Nitrate
260 µg/L 2.6%
of the EPA limit 10000 µg/L
 4/14 SYR4 2012–2019
TTHM
11.315 µg/L 14%
of the EPA limit 80 µg/L
worst single sample: 11.9 µg/L
4/4 SYR4 2012–2015
Total Haloacetic Acids (HAA5)
17.95 µg/L 30%
of the EPA limit 60 µg/L
worst single sample: 19 µg/L
4/4 SYR4 2012–2015
Fluoride
320 µg/L 8%
of the EPA limit 4000 µg/L
 3/3 SYR4 2012–2018
Barium
57.65 µg/L 2.9%
of the EPA limit 2000 µg/L
worst single sample: 60 µg/L
2/3 SYR4 2012–2018
Bromodichloromethane
2.73 µg/L
No EPA limit set
worst single sample: 2.8 µg/L
2/2 SYR4 2014
Bromoform
2.625 µg/L
No EPA limit set
worst single sample: 2.7 µg/L
2/2 SYR4 2014
Chloroform
1.6 µg/L
No EPA limit set
 2/2 SYR4 2014
Dibromochloromethane
4.655 µg/L
No EPA limit set
worst single sample: 4.8 µg/L
2/2 SYR4 2014
Arsenic
1 µg/L 10%
of the EPA limit 10 µg/L
 1/3 SYR4 2012–2018
Dibromoacetic Acid
3 µg/L
No EPA limit set
 1/1 SYR4 2015
Dichloroacetic Acid
3.6 µg/L
No EPA limit set
 1/1 SYR4 2015
Lead
0.0160 mg/L 107%
above the EPA limit of 0.0150 mg/L
 1/1 LCR 2010
Selenium
5.2 µg/L 10%
of the EPA limit 50 µg/L
 1/3 SYR4 2012–2018
64 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAntimony, TotalAsbestosAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneChromiumCombined UraniumDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ALEJANDRO NEWKIRK
Phone
626-768-9536

Frequently asked questions about Brady Hills Ml

Is Brady Hills Ml tap water safe to drink?

EPA monitoring detected 16 contaminants in Brady Hills Ml's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Brady Hills Ml's water?

EPA monitoring detected Copper, Lead, Nitrate, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Brady Hills Ml serve?

Brady Hills Ml reports serving 400 people in California, per its EPA record.

Has Brady Hills Ml had any water quality violations?

The EPA has 275 violations on file for Brady Hills Ml, of which 4 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.