Is T&T Mhp Tap Water Safe? Quality Report

Water source: Ground water
Ownership: Private
Counties served: Schuylkill

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

222

violations on file

still open

Violation	Type	Status	Period
MR	Monitoring	Resolved	2025-01-01 → 2025-12-31
MR	Monitoring	Resolved	2025-01-01 → 2025-12-31
MR	Monitoring	Resolved	2025-01-01 → 2025-12-31
MR	Monitoring	Resolved	2025-01-01 → 2025-12-31
MR	Monitoring	Resolved	2023-08-01 → 2023-08-31
MR	Monitoring	Resolved	2023-08-01 → 2023-08-31
MR	Monitoring	Resolved	2016-07-01 → 2016-09-30
MR	Monitoring	Resolved	2016-07-01 → 2016-09-30
MR	Monitoring	Resolved	2016-07-01 → 2016-09-30
MR	Monitoring	Resolved	2016-07-01 → 2016-09-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Nitrate	2800 µg/L 28% of the EPA limit 10000 µg/L	16/16	SYR4	2012–2019
Copper	118.4 µg/L 9.1% of the EPA limit 1300 µg/L worst single sample: 131 µg/L	15/15	SYR4	2013–2019
Lead	2.625 µg/L 18% of the EPA limit 15 µg/L worst single sample: 3 µg/L	6/15	SYR4	2013–2019
Lead	0.0531 mg/L 354% above the EPA limit of 0.0150 mg/L	3/3	LCR	2022
Arsenic	4.44 µg/L 44% of the EPA limit 10 µg/L worst single sample: 4.5 µg/L	2/3	SYR4	2012–2018
Barium	139 µg/L 7% of the EPA limit 2000 µg/L worst single sample: 140 µg/L	2/3	SYR4	2012–2018
Bromodichloromethane	4.8645 µg/L No EPA limit set worst single sample: 5 µg/L	2/3	SYR4	2012–2019
Chloroform	22.033 µg/L No EPA limit set worst single sample: 23 µg/L	2/3	SYR4	2012–2019
Chromium	5.58 µg/L 5.6% of the EPA limit 100 µg/L worst single sample: 5.8 µg/L	2/3	SYR4	2012–2018
Dibromochloromethane	1.0185 µg/L No EPA limit set worst single sample: 1.03 µg/L	2/3	SYR4	2012–2019
TTHM	27.709 µg/L 35% of the EPA limit 80 µg/L worst single sample: 28.8 µg/L	2/3	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	10.114 µg/L 17% of the EPA limit 60 µg/L worst single sample: 10.4 µg/L	2/3	SYR4	2012–2019
Combined Uranium	0.1371 µg/L 0.5% of the EPA limit 30 µg/L	1/1	SYR4	2013
Selenium	2.1 µg/L 4.2% of the EPA limit 50 µg/L	1/3	SYR4	2012–2018

65 contaminants tested, none detected

1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-DIBROMO-3-CHLOROPROPANE1,2-Dichloroethane1,2-Dichloropropane2,3,7,8-TCDD2,4,5-TP2,4-DAntimony, TotalAtrazineBhc-GammaBenzeneBenzo(A)PyreneBeryllium, TotalBromoformChlorobenzeneCyanideCadmiumCarbofuranCarbon TetrachlorideChlordaneDichloromethaneDalaponDi(2-ethylhexyl) AdipateDi(2-ethylhexyl) PhthalateDibromoacetic AcidDichloroacetic AcidDinosebDiquatEthylene DibromideEndothallEndrinEthylbenzeneFluorideGlyphosateHexachlorobenzeneHeptachlorHeptachlor EpoxideHexachlorocyclopentadieneLassoMercuryMethoxychlorMonobromoacetic AcidMonochloroacetic AcidNitriteOxamylPentachlorophenolPicloramSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTotal Polychlorinated Biphenyls (PCB)ToxapheneTrichloroacetic AcidTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact: DAVID OLT
Phone: 570-345-4539

Frequently asked questions about T&T Mhp

Is T&T Mhp tap water safe to drink?

EPA monitoring detected 14 contaminants in T&T Mhp's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in T&T Mhp's water?

EPA monitoring detected Nitrate, Copper, Lead, Lead, Arsenic, and others. The full list with the level and data source for each is above.

How many people does T&T Mhp serve?

T&T Mhp reports serving 40 people in Pennsylvania, per its EPA record.

Has T&T Mhp had any water quality violations?

The EPA has 222 violations on file for T&T Mhp, of which 0 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.