Tap WaterIndex

← Oklahoma

Tap water quality report

Antlers Pwa

EPA monitoring tested this supplier for 55 contaminants and detected 15. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

55
contaminants tested
15
detected
2,547
people served
399
health-based violations
Oklahoma rankingsLead in OklahomaPFAS in Oklahoma
Water source
Surface water
Ownership
Local government
Counties served
Pushmataha

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

399
health-based violations
433
violations on file
0
still open
ViolationTypeStatusPeriod
MCL Health-based Archived 2025-04-01 → 2025-06-30
MCL Health-based Archived 2025-04-01 → 2025-06-30
MCL Health-based Archived 2025-04-01 → 2025-06-30
MCL Health-based Archived 2025-04-01 → 2025-06-30
MCL Health-based Archived 2025-01-01 → 2025-03-31
MCL Health-based Archived 2025-01-01 → 2025-03-31
MCL Health-based Archived 2025-01-01 → 2025-03-31
MCL Health-based Archived 2025-01-01 → 2025-03-31
MCL Health-based Archived 2024-10-01 → 2024-12-31
MCL Health-based Archived 2024-10-01 → 2024-12-31

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Bromodichloromethane
17.34 µg/L
No EPA limit set
worst single sample: 23.7 µg/L
58/58 SYR4 2012–2019
Chloroform
107.25 µg/L
No EPA limit set
worst single sample: 128 µg/L
58/58 SYR4 2012–2019
Dichloroacetic Acid
31.83 µg/L
No EPA limit set
worst single sample: 49.7 µg/L
58/58 SYR4 2012–2019
TTHM
128.425 µg/L 161%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 139.49 µg/L
58/58 SYR4 2012–2019
Total Haloacetic Acids (HAA5)
66.195 µg/L 110%
of the EPA limit, at the 95th percentile of samples — 60 µg/L
worst single sample: 74.3 µg/L
58/58 SYR4 2012–2019
Trichloroacetic Acid
31.76 µg/L
No EPA limit set
worst single sample: 34.1 µg/L
58/58 SYR4 2012–2019
Dibromochloromethane
3.809 µg/L
No EPA limit set
worst single sample: 6.03 µg/L
47/58 SYR4 2012–2019
Copper
232.15 µg/L 18%
of the EPA limit 1300 µg/L
worst single sample: 520 µg/L
20/20 SYR4 2014–2017
Monochloroacetic Acid
4.624 µg/L
No EPA limit set
worst single sample: 5.29 µg/L
19/58 SYR4 2012–2019
Lead
0.0081 mg/L 54%
of the EPA limit 0.0150 mg/L
 14/14 LCR 2023
Lead
31.912 µg/L 213%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 60.88 µg/L
13/20 SYR4 2014–2017
Nitrate-Nitrite
290 µg/L 2.9%
of the EPA limit 10000 µg/L
 10/16 SYR4 2012–2019
Chlorite
681.8 µg/L 68%
of the EPA limit 1000 µg/L
worst single sample: 698 µg/L
7/9 SYR4 2012
Dibromoacetic Acid
1.0985 µg/L
No EPA limit set
worst single sample: 1.1 µg/L
2/58 SYR4 2012–2019
Barium
29.1 µg/L 1.5%
of the EPA limit 2000 µg/L
 1/1 SYR4 2018
40 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAtrazineBenzeneBeryllium, TotalBromoformChlorobenzeneCadmiumCarbon TetrachlorideChromiumCombined Radium (-226 And -228)Combined UraniumDichloromethaneEthylbenzeneFluorideGlyphosateGross Alpha, Excl. Radon And UGross Beta Particle ActivityLassoMercuryMonobromoacetic AcidSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
ANTLERS PUBLIC WORKS AUTHORITY
Phone
580-298-5635
Email
[email protected]

Frequently asked questions about Antlers Pwa

Is Antlers Pwa tap water safe to drink?

EPA monitoring detected 15 contaminants in Antlers Pwa's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Antlers Pwa's water?

EPA monitoring detected Bromodichloromethane, Chloroform, Dichloroacetic Acid, TTHM, Total Haloacetic Acids (HAA5), and others. The full list with the level and data source for each is above.

How many people does Antlers Pwa serve?

Antlers Pwa reports serving 2,547 people in Oklahoma, per its EPA record.

Has Antlers Pwa had any water quality violations?

The EPA has 433 violations on file for Antlers Pwa, of which 399 are health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.