Tap WaterIndex

← Ohio

Tap water quality report

Louisville City

EPA monitoring tested this supplier for 83 contaminants and detected 20. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

83
contaminants tested
20
detected
9,186
people served
0
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Ground water
Ownership
Local government
Counties served
Stark

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

0
health-based violations
41
violations on file
1
still open
ViolationTypeStatusPeriod
Other Monitoring Unaddressed 2026-01-07
Other Monitoring Resolved 2023-07-01
Other Monitoring Resolved 2023-07-01
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2013-01-01 → 2013-09-30
MR Monitoring Resolved 2010-07-01 → 2010-07-31

PFAS detected

PFAS are industrial “forever chemicals”. These are the EPA's latest nationwide test results (2023–2025).
ContaminantMaxDetection ratePeriod
Pfpea 0.0030 µg/L 1/2 2024

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
192.1 µg/L 15%
of the EPA limit 1300 µg/L
worst single sample: 1910 µg/L
39/40 SYR4 2014–2017
Bromodichloromethane
11.75 µg/L
No EPA limit set
worst single sample: 12.8 µg/L
31/31 SYR4 2013–2019
Chloroform
52.7 µg/L
No EPA limit set
worst single sample: 103 µg/L
31/31 SYR4 2013–2019
Dibromochloromethane
10.55 µg/L
No EPA limit set
worst single sample: 11.6 µg/L
31/31 SYR4 2013–2019
TTHM
87.86 µg/L 110%
of the EPA limit, at the 95th percentile of samples — 80 µg/L
worst single sample: 117 µg/L
27/27 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
23.65 µg/L 39%
of the EPA limit 60 µg/L
worst single sample: 34.4 µg/L
26/27 SYR4 2013–2019
Bromoform
3.422 µg/L
No EPA limit set
worst single sample: 3.84 µg/L
25/31 SYR4 2013–2019
Dichloroacetic Acid
8.886 µg/L
No EPA limit set
worst single sample: 28.6 µg/L
25/27 SYR4 2013–2019
Dibromoacetic Acid
4.2295 µg/L
No EPA limit set
worst single sample: 9.35 µg/L
24/27 SYR4 2013–2019
Trichloroacetic Acid
5.21 µg/L
No EPA limit set
worst single sample: 12.3 µg/L
21/27 SYR4 2013–2019
Lead
0.0012 mg/L 8.3%
of the EPA limit 0.0150 mg/L
 19/19 LCR 2023
Lead
5.3 µg/L 35%
of the EPA limit 15 µg/L
worst single sample: 6 µg/L
15/39 SYR4 2014–2017
Monochloroacetic Acid
2.856 µg/L
No EPA limit set
worst single sample: 2.91 µg/L
4/27 SYR4 2013–2019
Barium
134.8 µg/L 6.7%
of the EPA limit 2000 µg/L
worst single sample: 138 µg/L
3/3 SYR4 2013–2019
Fluoride
745.6 µg/L 19%
of the EPA limit 4000 µg/L
worst single sample: 751 µg/L
3/3 SYR4 2013–2019
Lithium
9 µg/L
No EPA limit set
 2/2 UCMR-5 2024
Chromium
1 µg/L 1%
of the EPA limit 100 µg/L
 1/3 SYR4 2013–2019
Selenium
1.52 µg/L 3%
of the EPA limit 50 µg/L
 1/3 SYR4 2013–2019
P-Dichlorobenzene
0.7000 µg/L 0.9%
of the EPA limit 75 µg/L
 1/4 SYR4 2013–2019
63 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-Dichloropropane11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaAntimony, TotalArsenicAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideDichloromethaneEthylbenzeneHfpo-DaLassoMercuryMonobromoacetic AcidNetfosaaNfdhaNmefosaaNitrateNitrate-NitriteNitritePfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpesPftaPftrdaPfunaSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
BABINGTON, SHELLY
Phone
330-875-5644
Email
[email protected]

Frequently asked questions about Louisville City

Is Louisville City tap water safe to drink?

EPA monitoring detected 20 contaminants in Louisville City's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Louisville City's water?

EPA monitoring detected Copper, Bromodichloromethane, Chloroform, Dibromochloromethane, TTHM, and others. The full list with the level and data source for each is above.

How many people does Louisville City serve?

Louisville City reports serving 9,186 people in Ohio, per its EPA record.

Has Louisville City had any water quality violations?

The EPA has 41 violations on file for Louisville City, of which 0 are health-based (a contaminant limit or required treatment was breached) and 1 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.