Tap WaterIndex

← Ohio

Tap water quality report

Anna Village

EPA monitoring tested this supplier for 53 contaminants and detected 16. A detection doesn't automatically mean the water is unsafe — the level and EPA source for each is below.

53
contaminants tested
16
detected
1,558
people served
7
health-based violations
Ohio rankingsLead in OhioPFAS in Ohio
Water source
Ground water
Ownership
Local government
Counties served
Shelby

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

7
health-based violations
77
violations on file
3
still open
ViolationTypeStatusPeriod
MCL Health-based Resolved 2000-09-01 → 2000-09-30
MCL Health-based Resolved 2000-09-01 → 2000-09-30
MCL Health-based Resolved 2000-09-01 → 2000-09-30
MCL Health-based Resolved 2000-09-01 → 2000-09-30
MCL Health-based Resolved 1999-08-01 → 1999-08-31
MCL Health-based Resolved 1999-08-01 → 1999-08-31
MCL Health-based Resolved 1999-08-01 → 1999-08-31
Other Monitoring Unaddressed 2026-01-14
Other Monitoring Unaddressed 2024-12-30
Other Monitoring Resolved 2024-07-01

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.
ContaminantLevel vs EPA limitDetection rateSourcePeriod
Copper
518.5 µg/L 40%
of the EPA limit 1300 µg/L
worst single sample: 576 µg/L
36/40 SYR4 2012–2019
Lead
0.0067 mg/L 45%
of the EPA limit 0.0150 mg/L
 20/20 LCR 2025
Bromodichloromethane
9.625 µg/L
No EPA limit set
worst single sample: 10.6 µg/L
14/14 SYR4 2013–2019
Chloroform
19.705 µg/L
No EPA limit set
worst single sample: 25.1 µg/L
14/14 SYR4 2013–2019
Dibromochloromethane
3.505 µg/L
No EPA limit set
worst single sample: 3.7 µg/L
14/14 SYR4 2013–2019
TTHM
33.055 µg/L 41%
of the EPA limit 80 µg/L
worst single sample: 40.4 µg/L
14/14 SYR4 2013–2019
Total Haloacetic Acids (HAA5)
14.175 µg/L 24%
of the EPA limit 60 µg/L
worst single sample: 19.7 µg/L
14/14 SYR4 2013–2019
Trichloroacetic Acid
6.645 µg/L
No EPA limit set
worst single sample: 7.1 µg/L
14/14 SYR4 2013–2019
Dichloroacetic Acid
8.56 µg/L
No EPA limit set
worst single sample: 11.5 µg/L
13/14 SYR4 2013–2019
Lead
19.565 µg/L 130%
of the EPA limit, at the 95th percentile of samples — 15 µg/L
worst single sample: 26 µg/L
12/40 SYR4 2012–2019
Nitrate
410 µg/L 4.1%
of the EPA limit 10000 µg/L
 12/16 SYR4 2012–2019
Nitrate-Nitrite
405 µg/L 4.1%
of the EPA limit 10000 µg/L
worst single sample: 410 µg/L
6/8 SYR4 2012–2019
Dibromoacetic Acid
3.595 µg/L
No EPA limit set
worst single sample: 4 µg/L
4/14 SYR4 2013–2019
Barium
99.38 µg/L 5%
of the EPA limit 2000 µg/L
worst single sample: 99.4 µg/L
3/3 SYR4 2013–2019
Bromoform
1.018 µg/L
No EPA limit set
worst single sample: 1.02 µg/L
3/14 SYR4 2013–2019
Fluoride
1204 µg/L 30%
of the EPA limit 4000 µg/L
worst single sample: 1210 µg/L
3/3 SYR4 2013–2019
37 contaminants tested, none detected
1,1,1-Trichloroethane1,1,2-Trichloroethane1,1-Dichloroethylene1,2,4-Trichlorobenzene1,2-Dichloroethane1,2-DichloropropaneAntimony, TotalArsenicAsbestosAtrazineBenzeneBeryllium, TotalChlorobenzeneCyanideCadmiumCarbon TetrachlorideChromiumDichloromethaneEthylbenzeneLassoMercuryMonobromoacetic AcidMonochloroacetic AcidNitriteSeleniumSimazineStyreneTetrachloroethyleneThallium, TotalTolueneTrichloroethyleneVinyl ChlorideXylenes, Totalcis-1,2-DichloroethyleneO-DichlorobenzeneP-Dichlorobenzenetrans-1,2-Dichloroethylene

Utility contact

Contact
KESSLER, WILLIAM
Phone
937-394-7363
Email
[email protected]

Frequently asked questions about Anna Village

Is Anna Village tap water safe to drink?

EPA monitoring detected 16 contaminants in Anna Village's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Anna Village's water?

EPA monitoring detected Copper, Lead, Bromodichloromethane, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Anna Village serve?

Anna Village reports serving 1,558 people in Ohio, per its EPA record.

Has Anna Village had any water quality violations?

The EPA has 77 violations on file for Anna Village, of which 7 are health-based (a contaminant limit or required treatment was breached) and 3 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.