Is Streetsboro City Tap Water Safe? Quality Report

Water source: GWP
Ownership: Local government
Counties served: Portage

Compliance record

Formal violations the EPA has on file for this supplier. A health-based violation means a contaminant limit or a required treatment was breached; the rest are monitoring or reporting failures — still violations, but not a measured health risk.

health-based violations

violations on file

still open

Violation	Type	Status	Period
MCL	Health-based	Resolved	2007-08-01 → 2007-08-31
MR	Monitoring	Resolved	2008-07-01 → 2008-07-31
MR	Monitoring	Resolved	2008-07-01 → 2008-07-31
MR	Monitoring	Resolved	2008-07-01 → 2008-07-31
MR	Monitoring	Resolved	2002-06-01 → 2002-06-30
MR	Monitoring	Resolved	2002-06-01 → 2002-06-30
MR	Monitoring	Resolved	2002-06-01 → 2002-06-30
MR	Monitoring	Resolved	2002-06-01 → 2002-06-30

Other contaminants detected

Each bar shows the measured level as a share of the EPA limit: green is well under, amber is close to it, red is over. For lead and copper the limit applies to exactly the 90th-percentile figure shown, so red there means a real exceedance. For everything else the limit applies to a running annual average while the figure is the 95th percentile of this system's samples — over 100% is worth reading, but is not by itself a violation. Where a single sample came in higher than that percentile, it is noted under the bar. Formal violations are listed separately.

Contaminant	Level vs EPA limit	Detection rate	Source	Period
Copper	316 µg/L 24% of the EPA limit 1300 µg/L worst single sample: 780 µg/L	230/241	SYR4	2013–2019
Bromodichloromethane	26.265 µg/L No EPA limit set worst single sample: 29.92 µg/L	116/116	SYR4	2012–2019
Bromoform	10.675 µg/L No EPA limit set worst single sample: 14.88 µg/L	116/116	SYR4	2012–2019
Chloroform	27.5725 µg/L No EPA limit set worst single sample: 39.4 µg/L	116/116	SYR4	2012–2019
Dibromochloromethane	25.225 µg/L No EPA limit set worst single sample: 31.07 µg/L	116/116	SYR4	2012–2019
TTHM	83.2325 µg/L 104% of the EPA limit, at the 95th percentile of samples — 80 µg/L worst single sample: 99.6 µg/L	116/116	SYR4	2012–2019
Dibromoacetic Acid	8.3162 µg/L No EPA limit set worst single sample: 8.972 µg/L	115/115	SYR4	2012–2019
Total Haloacetic Acids (HAA5)	19.123 µg/L 32% of the EPA limit 60 µg/L worst single sample: 20.21 µg/L	115/115	SYR4	2012–2019
Trichloroacetic Acid	5.4714 µg/L No EPA limit set worst single sample: 6.6 µg/L	114/115	SYR4	2012–2019
Dichloroacetic Acid	8.1 µg/L No EPA limit set worst single sample: 8.8 µg/L	109/115	SYR4	2012–2019
Lead	0.0 mg/L 0% of the EPA limit 0.0150 mg/L	25/25	LCR	2025
Lead	16.8 µg/L 112% of the EPA limit, at the 95th percentile of samples — 15 µg/L worst single sample: 18 µg/L	11/240	SYR4	2013–2019
Monochloroacetic Acid	8.4145 µg/L No EPA limit set worst single sample: 8.734 µg/L	11/115	SYR4	2012–2019
Monobromoacetic Acid	1 µg/L No EPA limit set	1/115	SYR4	2012–2019

30 contaminants tested, none detected

11Cl-PF3OUdS4:2 Fts6:2 Fts8:2 Fts9Cl-PF3ONSAdonaHfpo-DaNetfosaaNfdhaNmefosaaPfbaPFBSPfdaPfdoaPfeesaPfhpaPfhpsPfhxaPFHXSPfmbaPfmpaPFNAPFOAPFOSPfpeaPfpesPftaPftrdaPfunaLithium

Utility contact

Contact: WEIDELE, TOMMY
Phone: 330-626-2856
Email: [email protected]

Frequently asked questions about Streetsboro City

Is Streetsboro City tap water safe to drink?

EPA monitoring detected 14 contaminants in Streetsboro City's water. A detection isn't the same as a violation — most levels are within federal limits. See each level and source above, and the utility's annual Consumer Confidence Report for its official compliance status.

What contaminants were detected in Streetsboro City's water?

EPA monitoring detected Copper, Bromodichloromethane, Bromoform, Chloroform, Dibromochloromethane, and others. The full list with the level and data source for each is above.

How many people does Streetsboro City serve?

Streetsboro City reports serving 15,105 people in Ohio, per its EPA record.

Has Streetsboro City had any water quality violations?

The EPA has 8 violations on file for Streetsboro City, of which 1 is health-based (a contaminant limit or required treatment was breached) and 0 remain open. The rest are monitoring or reporting failures.

Where does this data come from?

Every figure is official EPA drinking-water monitoring — the Lead & Copper Rule, the UCMR-5 nationwide testing program, and the EPA Six-Year Review — not our own testing. Each number is labelled with its source and period.